I am looking for some ideas on how to install a UV sterilizer in a Reefer 350. How do people normally do this? I am currently just using flex hose to my return line.
A couple options I considered:
1.) Using a pump and just pumping some water out of the skimmer chamber, through the UV, and back into the skimmer chamber. I don't like this because you may be reprocessing the same already processed water.
2.) Splitting my overflow line into the sump and controlling flow with a ball valve. This is tricky bc how a Reefer is configured, also it is recommended to do this to post filtered water.
3.) Splitting my return line and controlling the flow through the UV with a ball valve and then putting it back into the return line farther down the line. Can this be achieved with all barbed fittings? Would this even work?
A couple options I considered:
1.) Using a pump and just pumping some water out of the skimmer chamber, through the UV, and back into the skimmer chamber. I don't like this because you may be reprocessing the same already processed water.
2.) Splitting my overflow line into the sump and controlling flow with a ball valve. This is tricky bc how a Reefer is configured, also it is recommended to do this to post filtered water.
3.) Splitting my return line and controlling the flow through the UV with a ball valve and then putting it back into the return line farther down the line. Can this be achieved with all barbed fittings? Would this even work?




