So Long story short.. I have a DYI roller mat as seen below.. the housing for the drive has some bolts ect above the water line.. but spray is causing a little rust.(its the roller on the right side with small power cord going into the small acrylic box.. that box is held in place to the roller drive inside the unit..
. I would like to cover them in some jelly to keep the rust in place. maybe just size of a pea .. even smaller..NOT a lot of rust mind you.. but would like to nip in bud. changing out the bolts that hold the drive is a project and might cause other issues... This seem like a quick easy fix.. or are there other products to use.. I could super glue but in the future that might be a big issues ... thanks
. I would like to cover them in some jelly to keep the rust in place. maybe just size of a pea .. even smaller..NOT a lot of rust mind you.. but would like to nip in bud. changing out the bolts that hold the drive is a project and might cause other issues... This seem like a quick easy fix.. or are there other products to use.. I could super glue but in the future that might be a big issues ... thanks
Last edited: