Vortec MP40 MP10 QD with Apex and anti sync

[Joe Batt]

Hi all
I have just connected my 2x MP40 to my Apex with WXM module and all working great.

A couple of questions about Anti Sync.

Say Left is on lagoon and Right is on lagoon. Will they be both at different random flows within the lagoon mode or both at the same power at the same time? Same goes for the other modes ie Tidal etc

If that is the case will Left in lagoon and right in anti sync mean if the left is on a high flow part of the lagoon cycle the right will be in a low flow part of the lagoon cycle? Same goes for other modes ie Tidal etc.

 

[ca1ore]

Whichever pump you designate as master will run the lagoon program; slave should say anti sync. Slave will run the inverse - so when master is at high part of lagoon, slave will be on the low part. You’ll see it reflected in the lit leds on the pump controller.

It’s been a while since I did this in my apex, so I always forget exactly how. Basically though when you setup the profiles, you have to designate which pump the anti sync profile will follow.