Vortech mp expert wanted

[Etienne 97]

Hi i have bought a lot of vortech 2 mp10 and 2 mp40 in the lot i have 3 mp40 driver and 1 mp10 driver can i use a mp 40 driver on a mp10 motor ?

 

[mmorrison55]

I wouldn’t risk it, but ive never tried.

A quick google search returned the following:

No, you cannot use an MP40 dry side with an MP10 wet side. The magnet strength and physical dimensions of the MP40 dry side motor are far too powerful and mismatched for the smaller MP10 wet side assembly.

Compatibility and Risks

• • Magnetic Mismatch: The MP40 dry side produces a much stronger magnetic field designed for a larger wet side and thicker glass.
  • Mechanical Failure: Pairing them will cause the magnets to misalign violently, lock up, rattle loudly, or create excessive friction that can strip or break the MP10 wet side ceramic shaft and bearings.
  • Overheating: The intense magnetic mismatch can force the MP40 dry side motor to work improperly or overheat

 

[Etienne 97]

I have seen that but in an other post i have read the controler are all the same so that is why am asking

 

[mmorrison55]

You may be ok. If you decide to try it, keep us posted on how it works out.

I don’t have any Mp10 wet sides or I would try it myself.

 

[Kooma]

You may be ok. If you decide to try it, keep us posted on how it works out.

I don’t have any Mp10 wet sides or I would try it myself.

Seems the OP is asking about a mp10 pump and a mp40 control pad, nothing to do with wet sides.

Can you clarify?

 

[Etienne 97]

I have done a test and i have plug the mp10 motor in a mp40 controler it is working but i dont know if my motor can handle it

 

[Kooma]

I have done a test and i have plug the mp10 motor in a mp40 controler it is working but i dont know if my motor can handle it

Only one way to find out.

 

[get-salty]

You have to remember that the mp40 wetside has a bigger magnet than the mp10.
absolutely would not use it this way unless you got them for zero to nothing dirty cheap.