Hello,
I am installing a Trigger Ruby 36S in a 4' tank stand. Most tank photos seem to show the drains dumping into the left side of the sump and the return pump on the right side.
If I install the Trigger sump in the traditional install, the filter socks are in the back left corner of the stand, and the skimmer is in the front/fore ground, so changing the filter socks will require working around the skimmer. If I rotate the Trigger 180 degrees, this will put the filter socks in the front, almost center of the stand, but then the skimmer will be towards the back and working on it will require working around the drain plumbing. The return pump would be in the rear left.
Thoughts? Suggestions?
Thank you
I am installing a Trigger Ruby 36S in a 4' tank stand. Most tank photos seem to show the drains dumping into the left side of the sump and the return pump on the right side.
If I install the Trigger sump in the traditional install, the filter socks are in the back left corner of the stand, and the skimmer is in the front/fore ground, so changing the filter socks will require working around the skimmer. If I rotate the Trigger 180 degrees, this will put the filter socks in the front, almost center of the stand, but then the skimmer will be towards the back and working on it will require working around the drain plumbing. The return pump would be in the rear left.
Thoughts? Suggestions?
Thank you