Wifi dual pump controller programming help .

gilman · May 8, 2020

Can I program the controller to run separate pump programs .
I have a 2k and 1k . I have the 2k running sine wave ramping up and down intensity through out the day .
I want the 1k to sun square wave at 100% from 6am until 10pm . Can it be done ?

Kyl · May 8, 2020

Icecap IC2GC - No, the pumps are mated to the same programming, though you can set one on "opposite" end so it runs in anti-sync mode during operation.
Wave Engine - Yes

gilman · May 9, 2020

Kyl said:
Icecap IC2GC - No, the pumps are mated to the same programming, though you can set one on "opposite" end so it runs in anti-sync mode during operation.
Wave Engine - Yes

What about through an Apex ? There are two 0-10v inputs right ? They control each pump separately right ?

TheHarold · May 9, 2020

gilman said:
What about through an Apex ? There are two 0-10v inputs right ? They control each pump separately right ?

Currently my impression was you need to choose one channel or the other. Maybe I am wrong

S.Pepper · May 9, 2020

Kyl said:
Icecap IC2GC - No, the pumps are mated to the same programming, though you can set one on "opposite" end so it runs in anti-sync mode during operation.
Wave Engine - Yes

Yup, I'm running the Hydros WaveEngine and the possibilities are endless with your pumps.