Wiring Motorized Ball Valve

[Stevorino]

I just received 4 of these motorized ball valves

I typically just get a plug from Home Depot and wire it into that, but I didn't know if there was a better/easier way to connect this to a plug to put into my Apex?

 

[Zayne]

I have serveral similar valves all using the accessory cable running off the 24v ports.

 

[Stevorino]

That is BRILLIANT! Thank you for the link!

Do you have a recommendation for a housing where the two wires connect?

 

[Zayne]

That is BRILLIANT! Thank you for the link!

Do you have a recommendation for a housing where the two wires connect?

I don't have mine in any kind of housing - just soldered, wrapped with electrical tape and some heat shrink. I use mine for RO/DI shut offs in the basement, not really near open water/humidy.

 

[Stevorino]

I don't have mine in any kind of housing - just soldered, wrapped with electrical tape and some heat shrink. I use mine for RO/DI shut offs in the basement, not really near open water/humidy.

Perfect- thanks so much!

I'm using mine for similar application. New RODI/Salt Reservoirs are hard to access and wanted the ability to just push go on Apex.

Thanks again!