Yerboy's rimless 190

  • Thread starter Thread starter Yerboy
  • Start date Start date
  • Tagged users Tagged users None
Yeah, they are definately better. When you get into the highter F stops it's important that nothing moves. I use a tripod and a remote shutter release so I don't move the camera pushing the button. I see you shot those w/ ISO 100. You might also try 200 or even 400 and see if that improves them.

The more you take the better they will be.
 
snapped a few photos at Mike's "Homegrown" yesterday. What ya think?
IMG_8091.jpg

8091cropped.jpg

I think i have to go back and buy this chalice piece. That thing looks amazing.
IMG_8092.jpg

IMG_8093.jpg

IMG_8094.jpg

IMG_8095.jpg

IMG_8096.jpg

All of these were shot by hand in RAW and adjusted for white balance post process in photoshop.
Harry i did as you suggested and pushed into the higher f stops and i think it came out nicely. Obviousely there is some blur due to being shot by hand with pumps running.
Enjoy

Looks pretty good. Keep practicing, you'll get better
 
Thanks Mike for letting me use the par meter. some shocking results "or not so shocking considering a 10 bulb powermodule"
IMG_9298.jpg

hopefully someone with more par knowledge then me can chime in and tell me if my par numbers are to high. i have had trouble with very slow growth rates on most corals with pale/brown colors since i set this tank up. some of my sps frags have encrusted several square inches without even a cm in growth in over a year. any ideas?
 
Your PAR numbers look good to me. If your having problems with growth I would say it has to be another factor. What are your water parameters? Especially ALK and Phosphate and PH.
 
i have been dosing 2 part since the tank was setup and maintained calcium around 390-410 and alk between 7-8dkh i haven't tested po3 in a long time but it was always around .01-0.3. temp is very stable at 78. my ph probe went crazy a few months ago and says the tank is around 9.4 but i know that isnt the case. prior to that ph stayed between 8.1-8.4

my issue has always been the light pastel colors that each coral would turn after a few weeks in my system.
take the orange/red monti in the pic below. this photo was taken a few days after being placed in my system

Picture037-1.jpg

just 2 months later it looked like this
IMG_6282.jpg
 
Last edited:
Jason;

That sounds like the same issue I previously had in my frag tank. Colors (especially blue and purple) would fade to pastel shades. For over a year I chased it with different lighting until I realized it had the same lighting that I had in my display tanks (maybe a little more). I even tried a couple of bottles of different kinds of snake oil. I finally decided that it was a nutrient deficiency since I was trying to feed very sparingly. I added more fish and fed them more frequently and I no longer have that issue. I know the my nutrients are pretty high because I notice a few hydroids (not colonial) that I didn't see before. Something to think about.
 
Yep, a lot of people say fish poop is the best coral food.
 
Yep, a lot of people say fish poop is the best coral food.

I would agree with both of H@rrys statements. I would also test for Phos. I had some of my corals start to fade and found my Phos was way way high. Like in the 2ppm range. This also stopped the growth dead I. It's tracks. When I lowered it back to .03 ppm the corals started growing and coloring back up again. Just something to think about. Also I find that montis need Mg and iodine. At least that's my experience. I keep my Mg high because of my chalices buty montis LOVE it. And also add 2 drops of lugols solution every 2 -3 days.
 
will test phos again and report back. mg is around 1450 last i checked "2 weeks"
 
Last edited:
I tend to agree with H@rry. I recall that you have a very high amount of light. You are driving your corals with a lot of light. The light is like the accelerator pedal on a car. The harder you push and the longer you hold it down, the faster the car goes and the more fuel it uses. Sooner or later your car (corals) run out of fuel and get pale or look dull colored. I saw this happen with H@rry's tank. H@rry solved his problem by feeding his corals with fish poop. Others do it with a bunch of additives. I find using fish is cheaper and adds more life to an aquarium.
 
I tend to agree with H@rry. I recall that you have a very high amount of light. You are driving your corals with a lot of light. The light is like the accelerator pedal on a car. The harder you push and the longer you hold it down, the faster the car goes and the more fuel it uses. Sooner or later your car (corals) run out of fuel and get pale or look dull colored. I saw this happen with H@rry's tank. H@rry solved his problem by feeding his corals with fish poop. Others do it with a bunch of additives. I find using fish is cheaper and adds more life to an aquarium.

Yep, a lot of people say fish poop is the best coral food.

I have fish, so would over skimming do the same thing? I am running a a 100 micron filter sock and a reputable skimmer sized for 3x my tank volume. It produces not much more than green tea. I feed Rod's somewhat generously, usually once a day. But everything seems to fade. I am "driving" my corals to an extent with the LEDs, but I don't think overly so. I really see it in my monti caps (as you have seen) and my birds nest. Some of this is due to high alk, I know (now corrected), but I am exploring other causes.
 
I tend to agree with H@rry. I recall that you have a very high amount of light. You are driving your corals with a lot of light. The light is like the accelerator pedal on a car. The harder you push and the longer you hold it down, the faster the car goes and the more fuel it uses. Sooner or later your car (corals) run out of fuel and get pale or look dull colored. I saw this happen with H@rry's tank. H@rry solved his problem by feeding his corals with fish poop. Others do it with a bunch of additives. I find using fish is cheaper and adds more life to an aquarium.

thanks Tomoko thats a scenario i never considered. With Mikes suggestion i also turned off 2 of my 10 T5s so im running only 8 bulbs. i hav a few fish on the way and have increased my feeding regime that im sure my fish will enjoy. Just seems like everything i increase feeding i get hair algae and cyno, so i have always been reluctant to feed allot. I watch mike feed 1/8 pack of rods each feeding and i cringe at the though of it.
 
I watch mike feed 1/8 pack of rods each feeding and i cringe at the though of it.

With a 300 gallon tang and a huge fish load I end up feeding a ton of rods and Rogers food weekly, I will use one of each every 10th day plus two sheets of nori per day. However I have the following fish load
7" sohal tang
7" vlamingi tang
7" blue jaw trigger
3" yellow
3" purple
3" chevron
3" flame fin
3" regal
8" powder blue
2" yellow eye kole
3" scopas
5" sailfin
12 green chromis
6 firefish
4 clowns (2 gold stripes and one orange and one black)
1 bi color Benny
1 starry blenny
1 potters angle
1 flame angle
1 melanarus wrasse

I end up with 1/2 gallon of the most terrible skimate everyday due to the amount of food and poop. I also do a 15 percent water change very Saturday.

My parameters are as follows and I am testing weekly with how young this tank is.
Salinity 1.025
Temp 80
Alk 7
Cal 420
Ph 8.2
Nitrite 0
Nitrate 5
Ammonia 0
Phosphate .001

I have sps, growing like weeds and lps that fat and happy with some softies doubling in size. The tank is lit up with 240 Cree LEDs using 6 different color spectrums, a vertex in-280 skimmer, 70 pounds of miracle mud and that's it.

This tank has just turned 9 weeks old and was setup with Virgin sand, rock, water and a few bottles of Dr. Tim's one and only bacterial additive. So far so good, dosing pump was added this weekend and set at 145 ml per day dosed three part evenly every 2nd hour.

b82c88ae-93d9-bb5b.jpg

b82c88ae-93f8-200a.jpg

b82c88ae-940e-89c0.jpg

b82c88ae-9429-cc95.jpg
 
Last edited:

TOP 10 Trending Threads

WHAT DO YOU ALWAYS RUN OUT OF AT THE WORST TIME?

  • Salt mix

    Votes: 17 18.9%
  • Fish or coral food

    Votes: 5 5.6%
  • Test kits or reagents

    Votes: 9 10.0%
  • Filter media or replacement fleece

    Votes: 5 5.6%
  • RO/DI filters or supplies

    Votes: 14 15.6%
  • Fragging and repair supplies, like glue or epoxy

    Votes: 10 11.1%
  • I keep a backup of everything

    Votes: 23 25.6%
  • Other (Post in the comments)

    Votes: 7 7.8%
Back
Top
Home
Post thread…
Market
What's new