5 stages RODI pressure issue

  • Thread starter Thread starter Krully
  • Start date Start date
  • Tagged users Tagged users None

Krully

Active Member
View Badges
Joined
Oct 29, 2019
Messages
284
Reaction score
301
Location
France
Rating - 0%
0   0   0
Hey guys. I previously had a 3 stages RODI unit with decent flow, nothing changed and I still have it to compare both the 3 stages and the 5 stages.
On the exact same setup the 5 stages is barely pulling anything as you can see in the video while the 3 stages is working perfectly fine. Is this to be expected? I know pressure itself wasn’t the issue on the 3 stages so I’m wondering if it can become one on 5 stages before ordering a booster pump. Thanks a lot.


Link to the video :
 
Do you know the actual PSI?

Adding extra stages would lower pressure in theory. I run 5 DI stages on mine and I’m sure there is pressure loss but I can visually see the difference. Maybe something is plugged or set up incorrectly on the 5?
 
I do not but this is something I’m going to try and figure out tomorrow.
Something might be plugged wrong although I did try with some membranes one way or another and it made no difference. I’m going to try and see if there’s something wrong about it but there were 0 instructions so I might have failed at some point. I’ll post some pictures for you guys to look at later when I get home.
 

TOP 10 Trending Threads

WHAT DO YOU ALWAYS RUN OUT OF AT THE WORST TIME?

  • Salt mix

    Votes: 17 18.9%
  • Fish or coral food

    Votes: 5 5.6%
  • Test kits or reagents

    Votes: 9 10.0%
  • Filter media or replacement fleece

    Votes: 5 5.6%
  • RO/DI filters or supplies

    Votes: 14 15.6%
  • Fragging and repair supplies, like glue or epoxy

    Votes: 10 11.1%
  • I keep a backup of everything

    Votes: 23 25.6%
  • Other (Post in the comments)

    Votes: 7 7.8%
Back
Top
Home
Post thread…
Market
What's new