- Joined
- Mar 31, 2019
- Messages
- 105
- Reaction score
- 86
I have four 6105 pumps connected to 7096 controller. All items are several years old (purchased used from multiple sellers ) & are set up to run in random mode (30%-100% power on all pumps).
I have a repeated issue with one pump. When using the feed mode, the pump will only re-start maybe 50% of time. If it doesn't re-start, I have to disconnect power supply & multicontroller link cable. Sometimes the pump will then start up once power is supplied. Sometimes it will run for a second, then stop & I then have to disconnect power again. I might have to do this a few times & then the pump will run fine.
I have the same issue when we have a power outage. The pump might re-start or I have to go through same procedure.
I have run the pump with 7090 controllers to rule out 7096 being the issue & pump has same problems. If I run pump without any controllers, it seems to start every time.
All pumps are maintained routinely & on surge protection. Am I looking at a new pump motor in the near future? Many thanks for your time.
I have a repeated issue with one pump. When using the feed mode, the pump will only re-start maybe 50% of time. If it doesn't re-start, I have to disconnect power supply & multicontroller link cable. Sometimes the pump will then start up once power is supplied. Sometimes it will run for a second, then stop & I then have to disconnect power again. I might have to do this a few times & then the pump will run fine.
I have the same issue when we have a power outage. The pump might re-start or I have to go through same procedure.
I have run the pump with 7090 controllers to rule out 7096 being the issue & pump has same problems. If I run pump without any controllers, it seems to start every time.
All pumps are maintained routinely & on surge protection. Am I looking at a new pump motor in the near future? Many thanks for your time.