Acropora issues

  • Thread starter Thread starter 10galtank
  • Start date Start date
  • Tagged users Tagged users None
A fan should help with the tank temp, although I wouldn't be super stressed, acropora generally like slightly higher temps then most corals. Not saying 30c is great for long periods, but before I had a chiller. my tank got up to 30c often in the summer. Did not lose any acro.

What are you dosing?
I found kalkwasser made a huge difference for me and things thrived on it and the ph boost is awesome!

I would also look at a ICP test to see if anything else is out of whack.

From my experience moving anything too fast with acro, stress RTN dead. Do not knee jerk react to parameter shifts, always amend slowly or trend, between a low and high point.

Phosphate swings I found did more damage then alk swings did both will cause RTN or STN! But can recover.

The other things I found that actually wiped all my acro out was, my RODI system filters expired and I did not get to it quick enough and so I was adding dirty unfiltered tap water and well, you guessed it RTN!
Fixed it with new filters and water changes and now everything is finally bouncing back (except the acro completely bleached every single one)

Get your fan going, send off a ICP to see if any minor elements are making your tank toxic. figure out what your dosing, what do you need to dose really.
Are you doing water changes?
filter some water and make up some fresh salt and do some water changes.
stay clear of marketing hype, cause most of it is garbage anyway.
I doubt the lights are an issue my corals have done well with kalkwasser, 2 part, and black box lights (although I have finally ordered some proper lights and waiting for delivery)
Thank you for the educated reply! To answer your questions, I dose All-For-Reef. It has been the one and only solution I have needed and have found great success with it in prior tanks. Water changes are frequent of mine, I use Bio-Actif salt. An ICP test would be nice here in the near future
 
What temp was that 13.5? Let's try eliminating temp as the cause.
 
Ambient temp is 78-79, no ceiling fan but two fans in room and yes is air conditioned. It is also a 40 breeder
This tank should not need a chiller. I would start by ensuring smoke surface agitation, and point a a/c vent toward the tank. Monitor for a few days, add a small fan blowing across the surface of water if needed. If that doesn't lower the temperature, then you need to evaluate humidity levels in your house. Too high and you won't gain much cooling from evaporation. Do you know how much water is added everyday for top off? And remember go slowly, don't need to drop the temperature in 2 hours.
 
Actually now thinking about it, what are you using to reduce phosphate levels? They are bouncing at pretty big rates, if your using GFO guarantee if your adding too much, you'll RTN your acro! Phosphates will do more damage then alk swings in my experience. .1 change in less then a day is quite a lot of difference
 
Aside from high temp, focus on stability. 6/21 alk is 9.5, 6/24 it's 8.4. Whenever my alk starts swinging I'll sometimes lose something.
 
I had the temp issue in my 10ish gallon biocube. It was a 110v pump that was getting ready to depart this earth. I put the same pump you have on it and I didn’t need to run a fan anymore and my ATO headaches went away as a result also. 85 is way way too warm.
 
Actually now thinking about it, what are you using to reduce phosphate levels? They are bouncing at pretty big rates, if your using GFO guarantee if your adding too much, you'll RTN your acro! Phosphates will do more damage then alk swings in my experience. .1 change in less then a day is quite a lot of difference onl

Actually now thinking about it, what are you using to reduce phosphate levels? They are bouncing at pretty big rates, if your using GFO guarantee if your adding too much, you'll RTN your acro! Phosphates will do more damage then alk swings in my experience. .1 change in less then a day is quite a lot of difference
I do not run any GFO or phosphate intended removing chemical. I carbon dose with NP-Bacto Pellets and Bio Actif Salt. Has lowered PO4 dramatically within its time frame of use, prior levels were stable about 0.4ppm
 
Aside from high temp, focus on stability. 6/21 alk is 9.5, 6/24 it's 8.4. Whenever my alk starts swinging I'll sometimes lose something.
Roger that. My tank stayed a steady 9.5dkh for a good while but recently decided to drop it a bit to see if that has any result. This lower alk range you see is very “new” to my system.
 
I had the temp issue in my 10ish gallon biocube. It was a 110v pump that was getting ready to depart this earth. I put the same pump you have on it and I didn’t need to run a fan anymore and my ATO headaches went away as a result also. 85 is way way too warm.
Which pump are you referring to? Thank you
 
I think it’s the UV sterilizer driving up the temperature. Unplug it for a day or two and I bet your temperature drops.
 
I think it’s the UV sterilizer driving up the temperature. Unplug it for a day or two and I bet your temperature drops.
Smart idea. It’s a 9w, think that pushes enough heat?
 

TOP 10 Trending Threads

WHICH PART OF YOUR SETUP IS HARDEST TO REACH OR REMOVE FOR ROUTINE MAINTENANCE?

  • Glass behind or beside the tank

    Votes: 12 18.2%
  • Powerheads or wavemakers

    Votes: 5 7.6%
  • Sump or rear filtration chambers

    Votes: 9 13.6%
  • Skimmer or other filtration equipment

    Votes: 9 13.6%
  • Overflow or plumbing

    Votes: 12 18.2%
  • Lights or lids

    Votes: 0 0.0%
  • Mine is pretty easy to access!

    Votes: 18 27.3%
  • Other—tell us what I missed

    Votes: 1 1.5%

New Posts

Back
Top
Home
Post thread…
Market
What's new