Apex jr with PM2 calibrating Conductivity Probe

[blizzardscout2]

So I have a PM2 lying around and wanted to add it to my Apex Jr and use a Conductivity Probe however when I prepped to calibrate it there is no option. I searched everywhere within Fusion. The tile showed up for Conductivity however there is no gear [emoji3541] icon that leads to the calibration page. The tasks have no Conductivity calibration like my Apex 2016 does.

I would connect to Apex.local but I cannot figure out how to connect to the Apex Jr as it defaults to my Apex 2016.

Any thoughts?

 

[Bob Escher]

I would presume the Jr has a different IP address than the 2016 model has. Your going to have to find that address and use that
Neptune has a utility on their website that you can use to find it

 

[vhuang168]

You cannot use apex.local to get to the local dashboard on the Apex Jr.

You need the IP address. You can look that up on the display module.

Main Menu > System > Net Setup > IP address