Apex Pro - Digital switch issue help

[cobraz]

Apex Pro - I configured a Digital switch by accident and can not figure out how to reset it to its default setting. It was for the wrong device.
I was trying to setup the water leveler and screwed this up...
Any help to default it to what it was before I changed..will gratefully be appreciated.

 

[pwoody]

Try going into your device tree

After that click alarms, and find the alarm that is going off, and click settings.
Just type “Set OFF” and save/upload.
This should stop the alarm.
If there is no alarm set it might be that you could find a similar setting within one of the other tree elements such as virtual outputs.

 

[pwoody]

Oh, another thing to try is going to the FMM device settings.
I set all mine to advanced, can you provide a picture of the code or settings within that device page? There will likely be something in there that relates to raising the virtual switch based on specific parameters.


As an example my return pump is set to turn off if the float switch bottoms out. (Sw6_Lo)

For your purposes you would simply remove this line of code.

 

[cobraz]

 

[cobraz]

Still can't edit it or rename it...

 

[SnowyFox]

Still can't edit it or rename it...

The configuration box is where you edit the name of the switch input. I don’t think you can delete it as it’s one of the 4 inputs on the FMM

 

[SnowyFox]

On the system tree page, you should also be able to tap on the gear icon for Alarm_1_2 under the FMM_1 device to bring up the config for that alarm. The default config code is just “Set OFF”

 

[cobraz]

 

[cobraz]

 

[cobraz]

Resolved.... I added the Water Level Sensor to the Digital Switch..it reset it to this device and I was able to rename at same time. No more crazy alarms..now I can turn it back on. Thanks for the input all.