Necrodaemus
Active Member
I was able to borrow an older Apogee mq200 from a local reefer, to dial in my LED lights. Which setting should be used, Sun or Electric and how accurate is this unit for measuring PAR from LEDs?
Apogee mq200 LED accuracy?
- Thread starter Necrodaemus
- Start date
- Tagged users None
you’re going to get much higher (inaccurate) readings with that one…
you want the mq510 for our reefing purposes.
it’s not that it’s completely unusable…
but readings will be 60-65% higher than the 510
perhaps you can make it work adjusting on that
you want the mq510 for our reefing purposes.
it’s not that it’s completely unusable…
but readings will be 60-65% higher than the 510
perhaps you can make it work adjusting on that
There is a correction factor. I don't remember it anymore, but you can look it up on Apogee's website. Make sure that you use it under water. Even if the numbers are not absolutely accurate, they can give you an idea of what spots in your tank are higher or lower than others.
The sensor on that one is soft near 400nm and also 700nm. There is light there that it will not capture.
The water might have to be very still to get consistent readings.
The sensor on that one is soft near 400nm and also 700nm. There is light there that it will not capture.
The water might have to be very still to get consistent readings.
Apogee MQ-200 par meter tips
Recently got a hold of a par meter, and I'm looking for some generic instructions on usage. I'm aware they reccomend a 1.08 correction factor for underwater, and that this model isn't as sensitive on the blue spectrum as the 500/501. I have LEDs, so I assume I'm correct to use the "SUN" mode...
www.reef2reef.com
Product Review: Apogee Instruments' PAR Meter (Model MQ-200) and Software
The Apogee MQ-200 Quantum Meter offers many advantages to aquarium hobbyists. The meter is relatively inexpensive (as quantum meters go) and the submersible sensor is small and allows measurements to be made in tight spots. Hobbyists should take a careful look and see if this PAR meter is for them.
reefs.com
Seems best to use sunlight mode.
Sensor response curve
Similar threads
