AquaC EV-240 Protein Skimmer

Peace River

Thrive Master
View Badges
Joined
Apr 29, 2014
Messages
25,006
Reaction score
174,215
Location
USA
What state or country do you live in
Florida
Rating - 100%
1   0   0
I picked up an AquaC EV-240 protein skimmer without the pump. Does anyone else have this skimmer or have used it in the past? I have been able to find the manual online and would appreciate any thoughts, recommendations, or tips about this skimmer.
 
Just get a gph ratted pump. I believe they ran 12-1800 gph pumps

Thank you for the feedback.

Yes. The manual recommended a few pumps including the Mag 12 or Mag 18. Have you used this skimmer (or seen it used)? How does it compare the the current needle wheel skimmers?
 
They are great skimmers. ...might need some tuning, but once tuned, you will see why some people will never replace these with a Needlewheel.

Mag 18 is a good choice. You cannot just put a DC 1800 GPH pump in there since they cannot handle the back pressure and will slow down too much. Laguna or Fluval of a similar size are good too.

Download this:
https://cdn.shopify.com/s/files/1/0015/9131/2445/files/EV-240.pdf?11667489451085625805
 
They are great skimmers. ...might need some tuning, but once tuned, you will see why some people will never replace these with a Needlewheel.

Mag 18 is a good choice. You cannot just put a DC 1800 GPH pump in there since they cannot handle the back pressure and will slow down too much. Laguna or Fluval of a similar size are good too.

Download this:
https://cdn.shopify.com/s/files/1/0015/9131/2445/files/EV-240.pdf?11667489451085625805

Thank you so much for the feedback! As always @jda, I have huge respect for you and your insights!
 
I’ve used an EV-240 with a Mag-12. As mentioned above a Mag-18 would be better. I was satisfied with how it performed after it was dialed in.
Make sure you clean out the air valve every once in awhile (will hurt foam production if it gets clogged). Just unscrew it from the base and rinse out, use a bottle brush if necessary.
 
Last edited:
I’ve used an EV-240 with a Mag-12. As mentioned above a Mag-18 would be better. I was satisfied with how it performed after it was dialed in.
Make sure you clean out the air valve every once in awhile (will hurt foam production if it gets clogged). Just unscrew it from the base and rinse out, use a bottle brush if necessary.

Great tip! Thanks for the feedback!
 

TOP 10 Trending Threads

WHAT DO YOU ALWAYS RUN OUT OF AT THE WORST TIME?

  • Salt mix

    Votes: 17 18.9%
  • Fish or coral food

    Votes: 5 5.6%
  • Test kits or reagents

    Votes: 9 10.0%
  • Filter media or replacement fleece

    Votes: 5 5.6%
  • RO/DI filters or supplies

    Votes: 14 15.6%
  • Fragging and repair supplies, like glue or epoxy

    Votes: 10 11.1%
  • I keep a backup of everything

    Votes: 23 25.6%
  • Other (Post in the comments)

    Votes: 7 7.8%
Back
Top
Home
Post thread…
Market
What's new