Hi Reefers,
I am looking to add a bit of automation to my RODI production. After what seems like hours searching the internet, I am no wiser than when I started- and now I start to feel stupid. Anyway, here is what I plan to do with my Neptune Apex in mind. Please advise
Option no. 1
2 x Optical sensors in my RODI bucket
1 x Float gauge as a backup
1 x Apex Solenoid (open when bottom sensor is exposed to air- and closed when water level reaches the top sensor?
Q: Will the backpressure from the float alone be enough to stop the flow of water?
Option no. 2:
Booster pump fitted before my RODI unit
Pressure switch to switch off the booster pump
2 x Optical sensors in my RODI bucket
1 x Float gauge as a backup
1 x Apex Solenoid (open when bottom sensor is exposed to air- and closed when water level reaches the top sensor?
Q: Where to I install the pressure switch, and how exactly does it work?
Q: Is my understanding correct that the back pressure from the closed solenoid will activate the pressure switch- which in turn will stop the booster pump?
Q: Will the backpressure from the float alone be enough to activate the pressure switch if the solenoid fail?
Thank you! Feel like an absolute idiot even asking
I am looking to add a bit of automation to my RODI production. After what seems like hours searching the internet, I am no wiser than when I started- and now I start to feel stupid. Anyway, here is what I plan to do with my Neptune Apex in mind. Please advise
Option no. 1
2 x Optical sensors in my RODI bucket
1 x Float gauge as a backup
1 x Apex Solenoid (open when bottom sensor is exposed to air- and closed when water level reaches the top sensor?
Q: Will the backpressure from the float alone be enough to stop the flow of water?
Option no. 2:
Booster pump fitted before my RODI unit
Pressure switch to switch off the booster pump
2 x Optical sensors in my RODI bucket
1 x Float gauge as a backup
1 x Apex Solenoid (open when bottom sensor is exposed to air- and closed when water level reaches the top sensor?
Q: Where to I install the pressure switch, and how exactly does it work?
Q: Is my understanding correct that the back pressure from the closed solenoid will activate the pressure switch- which in turn will stop the booster pump?
Q: Will the backpressure from the float alone be enough to activate the pressure switch if the solenoid fail?
Thank you! Feel like an absolute idiot even asking