Broke my nyos 160

[Stutters]

Hi all
So today I turned my water adjuster screw a little hard and it snapped. This is attached to the long tube from the skimmer body aka part 6. I’ve attached it below.

i haven’t tried it but if I buy a replacement part 6 is this long tube removable? Or is it stuck because from what I remember this part came assembled.

If it’s removable any suggestions or guides

any help appreciated thanks.

 

[PeterC99]

Yes, I have removed Part 6 for cleaning. If stuck, run joint where tube attaches under hot water, then gently twist apart. Careful to save gasket (Part 11).

Use email address from instructions to order a new part.

You will be back in business in no time!

 

[Stutters]

Dbl post

 

[Stutters]

Yes, I have removed Part 6 for cleaning. If stuck, run joint where tube attaches under hot water, then gently twist apart.

Use email address from instructions to order a new part.

You will be back in business in no time!

Does it twist from the base? And just pull through? And I guess I have to ask eco tech for the part?

 

[PeterC99]

Does it twist from the base? And just pull through? And I guess I have to ask eco tech for the part?

Yes - It twists apart from the base.

 

[Stutters]

Thanks a lot for the advice I’ll try it tomorrow hopefully just twists and it pulls away. It shows on the diagram there is a screw but maybe that’s not needed