Co2 degas question

  • Thread starter Thread starter akaemu
  • Start date Start date
  • Tagged users Tagged users None

akaemu

Active Member
View Badges
Joined
Mar 9, 2016
Messages
169
Reaction score
58
Location
Carroll County
What state or country do you live in
Maryland
Rating - 0%
0   0   0
Hello!

I need to degas my ro water before it hits the di stage and i am wondering if a 15gph pump would be too much or too little to feed the water into the di stage. The diagram I have shows a spectrapure ato pump being used which im not sure the gph of for this purpose but that is rather expensive.

Thanks
 
How do you know that you need to degas CO2? What is the PH of the water that you are trying to degas?
 
FWIW, the Spectrapure peristaltic pumps push about 150 ml/min. So that’s about 2.4 gph.
 
I have well water and have been told it may be the reason my di resin cartridge only lasts a short time. I bought a co2 test kit. I didn't use the ph calculation method.
 
Before spending any money, I would try your 15 gph pump. Can’t hurt to try. If you get 5 gallons of DI water an hour, you’d be pretty much right around what a 75 gpd RODI unit would produce.
 
When I was on well water, the only hope that I had was to get a 99+% rejection membrane and just eat the DI change costs. I also used the resin until the TDS hit 5 or 10. There was not a way around this that I found. Hope you figure it out, but tender your expectations... I used to get excited and then was disappointed later on.
 
When I was on well water, the only hope that I had was to get a 99+% rejection membrane and just eat the DI change costs. I also used the resin until the TDS hit 5 or 10. There was not a way around this that I found. Hope you figure it out, but tender your expectations... I used to get excited and then was disappointed later on.
I hear ya. Adding a booster pump and setting up a 55galon degasing container is my last resort. Elsewise ill just keep buying nutri sea water and distilled water.
 

TOP 10 Trending Threads

WHAT DO YOU ALWAYS RUN OUT OF AT THE WORST TIME?

  • Salt mix

    Votes: 15 18.1%
  • Fish or coral food

    Votes: 5 6.0%
  • Test kits or reagents

    Votes: 8 9.6%
  • Filter media or replacement fleece

    Votes: 4 4.8%
  • RO/DI filters or supplies

    Votes: 13 15.7%
  • Fragging and repair supplies, like glue or epoxy

    Votes: 10 12.0%
  • I keep a backup of everything

    Votes: 21 25.3%
  • Other (Post in the comments)

    Votes: 7 8.4%
Back
Top
Home
Post thread…
Market
What's new