Coral Box return pump settings help

[LgTas]

I've got a Coral Box return pump which has the in line controller. You push the button once and the light turns red and it pauses the pump for feeding time.

The problem I have is when it unpauses it goes to a lower flow setting? I've got it at level 5 but it returns to level 3. How do I set it to return back to the same flow level??

 

[minus9]

I've got a Coral Box return pump which has the in line controller. You push the button once and the light turns red and it pauses the pump for feeding time.

The problem I have is when it unpauses it goes to a lower flow setting? I've got it at level 5 but it returns to level 3. How do I set it to return back to the same flow level??

It should return to the same level you have programmed/selected. I would reach out to their support. I’ll have to check mine, I haven’t set it up yet on the new build, but I did test it and powered it off several times and it always returned to the same setting.

 

[LgTas]

Thanks! Good to know it's not something I'm doing wrong. I've dropped them a message.

 

[LgTas]

Just to close off this thread and provide an answer for anyone that searches for it in the future:

The pump automatically drops two speeds for the 1st hour post auto turning on. You can disable this. Instructions below: