I have a Waterbox 45.2, with a Nyos 3 return pump.
I had so much difficulty adjusting the flow rate when I first set up the tank, and now every time I do a water change to the point I kinda just give up and let it stay at whatever level.
I know this will be hard to believe, but there is probably a <2mm difference in adjusting the drain valve between the water level of the back chamber reaching the brim of the emergency valve, or reaching the bottom of the drain-basket. It is impossible for me to reach anywhere inbetween. The valve physically cant be turned in such small degrees.
I contacted waterbox and they only suggested sending me a new drain valve, which doesn't seem like it helped.
My return pump is on the LOWEST setting, or the return chamber will empty faster than it can be filled. Am I doing something wrong, or does this sound like a normal situation? Did I use the wrong return pump? Should I contact them again? I have no idea what to do
I had so much difficulty adjusting the flow rate when I first set up the tank, and now every time I do a water change to the point I kinda just give up and let it stay at whatever level.
I know this will be hard to believe, but there is probably a <2mm difference in adjusting the drain valve between the water level of the back chamber reaching the brim of the emergency valve, or reaching the bottom of the drain-basket. It is impossible for me to reach anywhere inbetween. The valve physically cant be turned in such small degrees.
I contacted waterbox and they only suggested sending me a new drain valve, which doesn't seem like it helped.
My return pump is on the LOWEST setting, or the return chamber will empty faster than it can be filled. Am I doing something wrong, or does this sound like a normal situation? Did I use the wrong return pump? Should I contact them again? I have no idea what to do