Hello all,
I built a 2x4 stand for my 75 gallon aquarium topped with 3/4 in plywood.
3 of the tanks corners touch but the 4th has this small gap at the corner. If I wiggle it I can just barely fit a credit card into the gap and it is the only corner where you can see light between the plywood and stand. (On the length of the tank there is a small 1/8-1/16 gap but the corners being tight is most important?)
Should I put a small shim between the top of the 2x4 stand and the 3/4 in pklwood to close the gap?
Thanks you for your time!
I built a 2x4 stand for my 75 gallon aquarium topped with 3/4 in plywood.
3 of the tanks corners touch but the 4th has this small gap at the corner. If I wiggle it I can just barely fit a credit card into the gap and it is the only corner where you can see light between the plywood and stand. (On the length of the tank there is a small 1/8-1/16 gap but the corners being tight is most important?)
Should I put a small shim between the top of the 2x4 stand and the 3/4 in pklwood to close the gap?
Thanks you for your time!