Cali9dub
Well-Known Member
If the 2.2 maxi stand alone utilizes it’s own port for level sensors once set as a slave to the P4 will that level sensor still work and be able to dictate how a pump will dose ??
Doser 2.2 Maxi
- Thread starter Cali9dub
- Start date
- Tagged users None
Users Who Are Viewing This Thread (Total: 1, Members: 0, Guests: 1)
How many level sensors do you use with your p4? With two dividers - a P4 can use 4 sensors and you can always use an extension card to add 4 more sensors. These senors can be used for regulation of the slave pumps you have connected to the P4. I use a Maxi 2.2 slave for my top off. I have switch socket to react on the sensor in level 1 function.
My dose program 21 is a Maxi 2.2 slave head and react on switch 5. When you use a Maxi 2.2 as top off pump you do not even need a physical switch - you can use a "virtual" (a switch channel without a physical socket)
Sincerely Lasse
My dose program 21 is a Maxi 2.2 slave head and react on switch 5. When you use a Maxi 2.2 as top off pump you do not even need a physical switch - you can use a "virtual" (a switch channel without a physical socket)
Sincerely Lasse
Gaël
Well-Known Member
Technically, a Doser SA in EXT (slave) mode is presented on the PAB bus as a real Doser EXT (slave).
A new device would have to be virtually created, an EXT Doser with temperature and level ports.
This would require a lot of work on firmware and software.
A new device would have to be virtually created, an EXT Doser with temperature and level ports.
This would require a lot of work on firmware and software.
OP
OP
Cali9dub
Well-Known Member
How many level sensors do you use with your p4? With two dividers - a P4 can use 4 sensors and you can always use an extension card to add 4 more sensors. These senors can be used for regulation of the slave pumps you have connected to the P4. I use a Maxi 2.2 slave for my top off. I have switch socket to react on the sensor in level 1 function.
My dose program 21 is a Maxi 2.2 slave head and react on switch 5. When you use a Maxi 2.2 as top off pump you do not even need a physical switch - you can use a "virtual" (a switch channel without a physical socket)
Sincerely Lasse
Wait. So where do you set up a virtual switch channel or do you just pick one you’ll never use…like switch channel 50 or something ? I assume the virtual switch channel turns on when a float switch triggers it, subsequently telling the maxi 2.2 pump to turn on until the float switch is no longer in “error” mode. Is that correct ??
Last edited:
Yes
And the switch channel not need to be a physical switch - you can use S62 if you want
Sincerely Lasse
Similar threads
