So I'm trying to upgrade to a 75G and haven't seen any good options locally so I picked up an Aqueon and decided to drill it myself. Yesterday I finally got around to doing the drilling. Had a hose on it the whole time, put 0 pressure and each of the 4 holes turned out slightly chipped on both the inside and outside of the tank:
No fracturing that I can see, just the chipping. Not sure what else I could have done. My driveway has a slight slope so I'm guessing I wasn't quite at the correct angle or something.
Is this safe to use as long as the gasket from the bulkhead covers the chipping fully on the inside?
No fracturing that I can see, just the chipping. Not sure what else I could have done. My driveway has a slight slope so I'm guessing I wasn't quite at the correct angle or something.
Is this safe to use as long as the gasket from the bulkhead covers the chipping fully on the inside?