Getting a higher display pH with a Calcium Reactor

reefandreptileautomation

Active Member
View Badges
Joined
Apr 9, 2019
Messages
261
Reaction score
128
Location
Arizona
What state or country do you live in
Arizona
Rating - 0%
0   0   0
So I have had a CaRx setup for a couple years now (10 ml/min, internal 6.8ph). The highest pH I can maintain in my display is around 8.1. While I have to use outside air to my skimmer to achieve it, I recently tried CO2 scrubbing. Same results. The CaRx must be really killing the PH in the display.

What options have people done to maintain a higher display pH? While I realize 8.1 is a just fine I would like to see if I can maintain a higher number for increased growth rates. I heard people use Kalk but how are people using it? I know running kalk in an ATO is a crap shoot as daily consumption of evaporation can change. Dripping kalk? Any suggestions would be greatly appreciated.

Thank you!
 
Although I think a pH of 8.1 is more than fine, if you want to boost your pH, supplement with kalk using a kalk reactor or stirrer with its own dedicated dosing pump.
 
You'd have to dial down the calcium reactor output and supplement with kalk to not spike alkalinity and calcium.

OR

Something I've been building up the supplies (and time/courage) to do, is a recirculating skimmer scrubber. I sent Water Dog a link already and got his opinion, but you have your skimmer input draw through a CO2 scrubber, and have that draw from your skimmer cup lid. Basically instead of drawing fresh air, it just keeps re-circulating scrubbed air. From the thread I saw this in, people actually have to put pH controls on their skimmer outlet, so they don't spike pH too high. I have the supplies, now I just have to drill my skimmer cup and move forward.

https://www.reef2reef.com/threads/recirculating-co2-scrubber.551353/
 
I have a vertex which has a secondary chamber.

I tried CO2 scrubber with no prevail.

Just to clarify, what I linked to is a recirculating scrubber, which sounds like it has a significantly more impactful effect on pH than a standard scrubber, as well as more efficient use of the media, since it is re-scrubbing already higher pH air. I just want to make sure you understood the difference.

Have you also considered a fuge or algae reactor, particularly one fed by your CaRx output? It'll absorb the co2 and oxygenate the water and increase pH that way as well.
 

TOP 10 Trending Threads

WHAT DO YOU ALWAYS RUN OUT OF AT THE WORST TIME?

  • Salt mix

    Votes: 17 18.9%
  • Fish or coral food

    Votes: 5 5.6%
  • Test kits or reagents

    Votes: 9 10.0%
  • Filter media or replacement fleece

    Votes: 5 5.6%
  • RO/DI filters or supplies

    Votes: 14 15.6%
  • Fragging and repair supplies, like glue or epoxy

    Votes: 10 11.1%
  • I keep a backup of everything

    Votes: 23 25.6%
  • Other (Post in the comments)

    Votes: 7 7.8%
Back
Top
Home
Post thread…
Market
What's new