- Joined
- Feb 28, 2017
- Messages
- 1,611
- Reaction score
- 1,044
How to set it up? I set mine up and both wave makers stopped
Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
so they have to be on anti-sync mode to work in gyre mode?I just programmed it into 2 MP 60s on each end of a tank. 100% 44 seconds anti sync.
It worked. The off pump still turns with no power.
do you understand the "time" section on gyre mode? What does it do? Why you set it up 44 seconds?I just picked some settings to try it. It didn't do anything unusual.
In gyre mode the pump runs at the set power for the set time and is then idle for the same time.
Usually you use 2 pumps that alternatively push water in different directions so it sets how long each pump runs in anti sync.
I found the problem. It is because I set the gyre pump to run for few seconds. When I set them up in much longer running time they work.@canadianeh, sync and anti sync is a must if you want multiple pumps to work in tandum.
Setting one pump as the parent and making the others the child. Depending on what you select the child to be (sync or anti sync) will either copy or run opposite the parent.
The initial problem you were having with the pumps not moving, probably meant that you only had to power cycle the vortechs to basically reboot them.