Head pressure rough estimate?

Readywriter

Active Member
View Badges
Joined
Sep 1, 2014
Messages
329
Reaction score
349
Location
usa
Rating - 0%
0   0   0
Im in the planning/gathering equipment phase of setting up 2 dt's on one sump. One of the tanks will be a couple feet away from the sump with a couple turns in the plumbing. I saw the brs article that says each 90* turn = 1' hp. Is it that cut and dry or is there a more scientific way to calculate?
 
I think that is a way of estimating the impacts of fittings on pump output. Most people don't care to know the output exactly, they are aiming for a range, with the lower end greater than zero. A lot of pumps are available that struggle with pressure and the estimates are provided so folks can avoid getting one of those.

New pumps should provide a maximum head number for planning. Some pumps are listed as pressure pumps, the others are flow, again as general ways to decide if they will fit your application. Pressure pumps for going up a story in the house and flow pumps, with flow ratings at head distances typical for short aquarium lifting purposes.
 

TOP 10 Trending Threads

WHAT DO YOU ALWAYS RUN OUT OF AT THE WORST TIME?

  • Salt mix

    Votes: 17 18.7%
  • Fish or coral food

    Votes: 5 5.5%
  • Test kits or reagents

    Votes: 9 9.9%
  • Filter media or replacement fleece

    Votes: 5 5.5%
  • RO/DI filters or supplies

    Votes: 14 15.4%
  • Fragging and repair supplies, like glue or epoxy

    Votes: 10 11.0%
  • I keep a backup of everything

    Votes: 24 26.4%
  • Other (Post in the comments)

    Votes: 7 7.7%
Back
Top
Home
Post thread…
Market
What's new