ccombs
Valuable Member
Hello Everyone,
I searched the forums and did not find what I need/ I actually found conflicting evidence to what I am posting so I need some clarification.
I have an IceCap Gyre 1K, An IceCap Gyre 1K interface Module Specifically for it https://www.bulkreefsupply.com/gyre-interface-module-for-1k-pumps-icecap.html , and an Apex System. I have read people saying the Icecap Gyres are not compatible with Apex. However, this interface seems to indicate otherwise. It specifically says on BRS that it is for Icecap 1K Gyres and Apex.
I am running the interface per the instructions and am using the alternating directions cable. My programming is attached.
Every few seconds the pump runs for half a second, stops for 5-10 seconds, then runs again for about half a second. What am I missing here?
I searched the forums and did not find what I need/ I actually found conflicting evidence to what I am posting so I need some clarification.
I have an IceCap Gyre 1K, An IceCap Gyre 1K interface Module Specifically for it https://www.bulkreefsupply.com/gyre-interface-module-for-1k-pumps-icecap.html , and an Apex System. I have read people saying the Icecap Gyres are not compatible with Apex. However, this interface seems to indicate otherwise. It specifically says on BRS that it is for Icecap 1K Gyres and Apex.
I am running the interface per the instructions and am using the alternating directions cable. My programming is attached.
Every few seconds the pump runs for half a second, stops for 5-10 seconds, then runs again for about half a second. What am I missing here?
