Help with my vortech

[ankyv]

Hi guys,
Does anyone know if I can connect my mp40wes with qt in master slave mode

 

[Reef Tripp]

Yes, manually or reeflik, not in mobius

 

[carmodpg]

I believe that you can. Would have to do it through ESL unless you upgraded your RF module.

 

[ankyv]

I can’t sync them manually I try so many times after doing reset to both of them

 

[Reef Tripp]

Both are W, I recommend you open both controllers and check that the RF chip is well placed or remove it and reinsert and seen many cases with this simple error, by the way if you want to control in mobius you would have to upgrade to the black chip

 

[ankyv]

I use to I have 1 mp40 and 1 mp10 and I bought a brand new mp40 qt.the old one where in sync mode so I don’t think there is a ploblem ....

 

[ankyv]

Both are W, I recommend you open both controllers and check that the RF chip is well placed or remove it and reinsert and seen many cases with this simple error, by the way if you want to control in mobius you would have to upgrade to the black chip

The problem is something else I believe..
I think there is a problem in the new one
The manual says enter configuration mode and then press mode to assign master.when I press mode the color becomes green and not green blue.on the other hand the other vortech starts flashing blue yellow.
So I tried to make my old one master and I see the same thing
When I enter the configuration mode and press set to qt it constantly becomes green.i ve read about ref chip you write above but I try to connect to Mobius and works ok
Any suggestions?

 

[ankyv]

Problem solver by eco tech support!!!
Changes made to the controller and all the new model are not available to pair manually only with mobius.
Also night mode and feed mode via mobius as well.so if you have an older qt you have to upgrade with the new rf chip if you want to pair them and only with mobius.