Icp test came back need some advice

[mjuarez7]

Hey guys just got my Ati Basic Seawater Icp back today, I’ve never done one. I just beat LCA Dino’s by dosing waterglass to outcompete with a diatom bloom. Silicates are through the roof which I guess is normal since I dosed it, it’s been about 3 weeks since I stop dosing waterglass. My phosphates and strontium are pretty high, I added 1/2 cup of rowaphos in a media bag in a high flow area in sump is this a good starting point? As far as strontium being high is it because I’m dosing All For Reef? Planning on dosing brightwell iodium too. Also they said my salinity was 31 PSU which they say is critically low, I’ve always calibrated with RODI to Zero so I went to grab some brightwell calibration solution and tested with the calibrated refractometer and my display is sitting at 35ppt so idk what up with that lol. Any tips would be appreciated thanks guys Happy reefing. Also added an Og bounce before I knew these results and it melted overnight is there something here specifically that would’ve caused that?

 

[slingfox]

You cannot trust those off the shelf salinity calibration solutions. Least brain damage way to calibrate is to use a Tropic Marine Hydrometer.

I personally use a VeeGee refractometer and calibrate with RODI and the last 3 ICPs I have been pretty much dead on in terms of salinity. Here is the last one:

 

[ReeferTCG]

What Ive heard from is that if your salinity is not around the right salinity its not a fair comparison on the critical low. Since ions are not going to be in the correct levels to begin with.

I would not raise salinity more than 1.5 - ppt in one water change tho

 

[EnterName]

Phosphate has to be measured with photometry in order to be accurate, so ATI's ICP phosphate levels will always be above actually dissolved phosphate.
That's also why Oceamo measures it using photometry even though they have access to ICP as well.

A ULR Phosphate checker from Hanna Instruments together with their calibration solution will help a lot to get accurate results.

Regarding salinity I prefer a high quality hydrometer or digital tester, but if you want to use a refractometer you might want to take a look at Randy's DIY calibration standards: https://www.reef2reef.com/ams/reef-aquarium-salinity-diy-calibration-standards.956/

 

[Randy Holmes-Farley Verified Community Expert]

Not sure if the silicon reading is accurate, but if true is quite high. Are you using tap water?

Do you have any apparent problem with pest diatoms being excessive?