@Ditto @Vinny@GHLUSA
Here goes my long story.
I downloaded the new GCC version on my new laptop. I upgraded the firmware without backing up my files. I know big mistake. After the update everything was set to factory settings. I thought ok ill just start from scratch no biggie. Well i had issues with the wifi so i went on and found the directions for resetting the wifi chip and followed them to a T. After that i tried following the directions to set up a new p4 via app. When i power off the p4 and then power on and select next to connect via access mode i keep getting a cannot connect error. Alright fine ill do it in GCC. My GCC wont connect either. When i plug in the usb cable i get a note from my laptop that says the driver install malfunctioned. So i go in and delete the driver from my pc and reinsert the usb. It downloads and all seems to be good but i still cannot connect in gcc or if i try doing the wifi reset again. My computer will tell me about 5 minutes later that the usb driver malfunctioned and it tells me its on my devices end.
Long stotry short i cannot connect to this thing at all now in gcc, the app, or using the wifi tool. If i use the wifi tool it tells me the port is in use already but its not.
Please help
Here goes my long story.
I downloaded the new GCC version on my new laptop. I upgraded the firmware without backing up my files. I know big mistake. After the update everything was set to factory settings. I thought ok ill just start from scratch no biggie. Well i had issues with the wifi so i went on and found the directions for resetting the wifi chip and followed them to a T. After that i tried following the directions to set up a new p4 via app. When i power off the p4 and then power on and select next to connect via access mode i keep getting a cannot connect error. Alright fine ill do it in GCC. My GCC wont connect either. When i plug in the usb cable i get a note from my laptop that says the driver install malfunctioned. So i go in and delete the driver from my pc and reinsert the usb. It downloads and all seems to be good but i still cannot connect in gcc or if i try doing the wifi reset again. My computer will tell me about 5 minutes later that the usb driver malfunctioned and it tells me its on my devices end.
Long stotry short i cannot connect to this thing at all now in gcc, the app, or using the wifi tool. If i use the wifi tool it tells me the port is in use already but its not.
Please help