Looking for vortech mp10 bearings

[chaostactics]

Looking to replace the bearings on the dryside of my mp 10. Anyone know where to look?

 

[Steve P]

Do you have it disassembled yet? Does it have a number on it?

 

[chaostactics]

It's too faint to read

 

[ca1ore]

There's a long thread on RC about replacing bearings. Haven't read it (never have needed to do anything to any of my drysides) but perhaps there are suggestions on what to use contained therein.

 

[chaostactics]

The thread seems to cover the MP40.

 

[Steve P]

If you can figure out the dimensions of it, go to bocabearings.com and search there.

 

[cromag27 Verified Sponsor]

It can be a tricky procedure. If the screws have seized then you're, well......screwed.

 

[cromag27 Verified Sponsor]

Just found a couple new bearings I was going to use in an old mp10. Should be the right size as I read a few threads that advised what size to get.

 

[chaostactics]

Just found a couple new bearings I was going to use in an old mp10. Should be the right size as I read a few threads that advised what size to get.

I couldn't find those particular threads. But maybe I didn't "look right". Nothing has seized on mine. I had the whole thing apart and tried to live it but true to their name you can live sealed bearing.

 

[cromag27 Verified Sponsor]

You want my pair?

I couldn't find those particular threads. But maybe I didn't "look right". Nothing has seized on mine. I had the whole thing apart and tried to live it but true to their name you can live sealed bearing.

 

[Steve P]

If the bearing has rubber seals, they can be removed, if you take care doing so, and replaced. Metal shields however get damaged in the process.

 

[chaostactics]

If the bearing has rubber seals, they can be removed, if you take care doing so, and replaced. Metal shields however get damaged in the process.

Bearings are metal sheilds

 

[chaostactics]

You want my pair?

Ygpm

 

[chaostactics]

Fyi for anyone looking

 

[chaostactics]

And the other bearing

 

[Steve P]

Those are good sizes anyone can pick up at their local bearing distributor (Motion, Kaman, Applied, etc.). That second pic has 2 part numbers on it; both are valid but the 696ZZ is more recognizable.

 

[Chris155hp]

is this the QD version?

 

[chaostactics]

is this the QD version?

It wasnt the quiet drive version but i did get the quiet drive version open and its pretty much the same deal. Though i didnt check the bearing size/model