Modular Marine Plumbing

[samnaz]

https://www.reef2reef.com/threads/q...&share_tid=595633&share_fid=1020&share_type=t

Not found?

 

[CindyKz]

Sorry I think it is because I was using Tapatalk. This should work:

https://www.reef2reef.com/threads/question-for-plumbing-experts.595633/#post-6026235

 

[Idiotsavant]

I know it’s been a while since you posted this but can you show me a picture. Modular Marine is telling me to cut the threaded side of the bulkhead so I can raise my emergency drain. I’m afraid to do this because it will screw up the threads.

https://www.reef2reef.com/threads/q...&share_tid=595633&share_fid=1020&share_type=t

 

[Idiotsavant]

I know it’s been a while since you posted this but can you show me a picture. Modular Marine is telling me to cut the threaded side of the bulkhead so I can raise my emergency drain. I’m afraid to do this because it will screw up the threads.

 

[idiotsavant3]

Unfortunately, my rear box is drilled differently. All the holes are drilled under where the bulkhead sticks out.

It makes no sense to me.

I know it’s been a while since you posted this but can you show me a picture. Modular Marine is telling me to cut the threaded side of the bulkhead so I can raise my emergency drain. I’m afraid to do this because it will screw up the threads.

I know this is an old thread. But I have the newest design of the 1600+ gph Overflow on my 75 gallon and avoided the whole situation of having to cut the threads off of the 1-1/2" bulkheads by purchasing a pair of 1-1/2" SHORT slip x slip Bulkheads.