New Reeflink- Cannot Locate MP10wQD

[clowninaround74]

I just purchased a Reeflink in hopes to use it with my two MP10wes that I recently upgraded to MP10wQD. The Reeflink is set up, connected to ESL and the ring of LED's is blue, but in ESL, the MP10's cannot be located. I have tried powering down both pumps and turning them back on and nothing.

I tried searching online and everything I can find is to update the firmware for the non QD drivers. I am totally lost here...

Can anybody help me to get these connected so I can start using the Reeflink with them??

Thank you

 

[lyrical]

I have no idea if this is correct or helpful but if your pumps are setup as master/slave you might want to try resetting them back to normal mode. No idea if this would make any difference to the reeflink. I would also check to make sure the wireless chips are working and/or there. I bought a 40 what the W wasn't lighting up and their was no wireless chip installed.

 

[Diesel]

^^^^^ check for the Wireless chip!
If you bought the pumps new they'll send you the chips for free.

 

[clowninaround74]

Good ideas! The wireless chip is working and the W is lit up on both control units, but they are currently set up as master/slave. I'll try to reset them back and see if that helps!

Thank you

 

[clowninaround74]

That worked! Thank you!

 

[lyrical]

Awesome :)