Nitrites

  • Thread starter Thread starter jrawk1120
  • Start date Start date
  • Tagged users Tagged users None

jrawk1120

Active Member
View Badges
Joined
Jun 15, 2015
Messages
246
Reaction score
127
Location
MA/CT
Rating - 0%
0   0   0
So I’m a little confused at my elevated nitrites and my almost undetectable ammonia

I use the Hanna Marine Master.

My readings today

Salinity - 1.025
Ammonia - .08ppm
Nitrites - 36ppb
Nitrates - 26.8ppm
Alk - 9.3dkh
Calcium - 590ppm
Magnesium - 1520ppm
Ph - 7.7

So my apex registers my Ph at 8.26 currently, so I’m not sure of the discrepancy there.

My nitrites have gone up. Tested last week and they were at 24. So I’m not sure what is contributing to the rise.

I haven’t lost any fish, nothing dying. Water change earlier today of 10%

I have a bit of an outbreak of cyano at the moment. But I don’t think those are tied
together.

Anything I should be looking for?
 
Ammonia turns into nitrites which are then consumed by nitrates. It'll get to a point in your cycle and tank's life that you will stop testing for both ammonia and nitrites. You're still cycling your tank by the sounds of it. You'll get a spike in your nitrites as long as you have ammonia in your system. Eventually your nitrates will spike as it consumes your nitrites. Once the tank is fully cycled you'll have zero ammonia and nitrites.
 
That Nitrite level is very low, and even if it were 1000 times higher, would not kill fish.

Ignore nitrite. :)
 
So I’m a little confused at my elevated nitrites and my almost undetectable ammonia

I use the Hanna Marine Master.

My readings today

Salinity - 1.025
Ammonia - .08ppm
Nitrites - 36ppb
Nitrates - 26.8ppm
Alk - 9.3dkh
Calcium - 590ppm
Magnesium - 1520ppm
Ph - 7.7

So my apex registers my Ph at 8.26 currently, so I’m not sure of the discrepancy there.

My nitrites have gone up. Tested last week and they were at 24. So I’m not sure what is contributing to the rise.

I haven’t lost any fish, nothing dying. Water change earlier today of 10%

I have a bit of an outbreak of cyano at the moment. But I don’t think those are tied
together.

Anything I should be looking for?
How old is the aquarium?

Is the nitrite reading NO2-N (nitrite nitrogen) or nitrite? If the former, the actual level is 46/14 higher. This is only important with respect to first question and the slightly elevate ammonia.
 
So I’m a little confused at my elevated nitrites and my almost undetectable ammonia

I use the Hanna Marine Master.

My readings today

Salinity - 1.025
Ammonia - .08ppm
Nitrites - 36ppb
Nitrates - 26.8ppm
Alk - 9.3dkh
Calcium - 590ppm
Magnesium - 1520ppm
Ph - 7.7

So my apex registers my Ph at 8.26 currently, so I’m not sure of the discrepancy there.

My nitrites have gone up. Tested last week and they were at 24. So I’m not sure what is contributing to the rise.

I haven’t lost any fish, nothing dying. Water change earlier today of 10%

I have a bit of an outbreak of cyano at the moment. But I don’t think those are tied
together.

Anything I should be looking for?
How old is the aquarium?

Is the nitrite reading NO2-N (nitrite nitrogen) or nitrite? If the former, the actual level is 46/14 higher. This is only important with respect to first question and the slightly elevate ammonia.
I’ll edit my post but my tank is about 8 months old.

No new additions except some birds nest
 
Ammonia turns into nitrites which are then consumed by nitrates. It'll get to a point in your cycle and tank's life that you will stop testing for both ammonia and nitrites. You're still cycling your tank by the sounds of it. You'll get a spike in your nitrites as long as you have ammonia in your system. Eventually your nitrates will spike as it consumes your nitrites. Once the tank is fully cycled you'll have zero ammonia and nitrites.
I’m about 8 months in.
 
So I’m a little confused at my elevated nitrites and my almost undetectable ammonia

I use the Hanna Marine Master.

My readings today

Salinity - 1.025
Ammonia - .08ppm
Nitrites - 36ppb
Nitrates - 26.8ppm
Alk - 9.3dkh
Calcium - 590ppm
Magnesium - 1520ppm
Ph - 7.7

So my apex registers my Ph at 8.26 currently, so I’m not sure of the discrepancy there.

My nitrites have gone up. Tested last week and they were at 24. So I’m not sure what is contributing to the rise.

I haven’t lost any fish, nothing dying. Water change earlier today of 10%

I have a bit of an outbreak of cyano at the moment. But I don’t think those are tied
together.

Anything I should be looking for?
How old is the aquarium?

Is the nitrite reading NO2-N (nitrite nitrogen) or nitrite? If the former, the actual level is 46/14 higher. This is only important with respect to first question and the slightly elevate ammonia.
8 months and it is reading it as No2-N. Good to know, thank you
 
I’ll edit my post but my tank is about 8 months old.

No new additions except some birds nest
As Randy indicated, this is not a dangerous situation. I’d add that seeing this much nitrite and ammonia after eight months seems unusual. I would keep measuring both, but not too often, just to confirm that both measurements are trending down.
 
Corals prefer to use ammonia over nitrate as a nitrogen source.

Do corals use nitrite?
 
Do corals use nitrite?

Might be true. They reportedly make nitrite from nitrate, so they might use nitrite directly:

The fact that nitrite is extracted from coral and algal tissue even when not present in the seawater suggests that the nitrate consumed is reduced by metabolic processes of the zooxanthellae.


https://scholar.google.com/scholar?...=#d=gs_qabs&t=1753100624461&u=#p=4m8reI6DeZ0J
Looking forward to the DIY nitrite dosing thread
 

TOP 10 Trending Threads

IF ONE SYSTEM FAILED WHILE YOU WERE AWAY, WHICH WOULD WORRY YOU MOST?

  • Power or backup power

    Votes: 5 21.7%
  • Heating or cooling

    Votes: 1 4.3%
  • Auto top-off

    Votes: 3 13.0%
  • Return pump or water circulation

    Votes: 1 4.3%
  • Dosing or automated testing

    Votes: 0 0.0%
  • Plumbing, overflow, or leaks

    Votes: 5 21.7%
  • Tank sitter or remote monitoring

    Votes: 1 4.3%
  • Electrical failure of some sort

    Votes: 0 0.0%
  • Seam or structure failure

    Votes: 4 17.4%
  • Something else (tell us in the comments)

    Votes: 3 13.0%
Back
Top
Home
Post thread…
Market
What's new