Overflow Standpipe Question

  • Thread starter Thread starter PeterG
  • Start date Start date
  • Tagged users Tagged users None

PeterG

Active Member
View Badges
Joined
Aug 30, 2017
Messages
286
Reaction score
155
Location
St. Pete Beach, FL
What state or country do you live in
Florida
Rating - 0%
0   0   0
Last week I had an aquarium maintenance person come over to hook up a new sump (Trigger Systems Emerald 26) as it needed some plumbing changes beyond my abilities.
I also had him change/update my corner overflow to a Durso Standpipe.
It’s working fine but a couple things concern me:
My old standpipe (photo attached) had a foam filter which acted as a pre-filter before the water entered the sump. The Durso does not have any sort of filter material.
It also barely fits in that corner opening which is why it sits slightly askew (photo attached). It will also be much harder to clean that area later on.

Would I be better off switching back to my old standpipe? Not sure what it’s called as itt came with the tank when I got it as a freebie a couple of years ago. It has an elliptical cut in the pipe and the top is a float which controls the water level.
Overflow_old.jpg
Overflow_New.jpg
 
Unfamiliar with the top picture, but you could use a couple of 45 degree PVC fittings to offset the durso slightly.
 
Unfamiliar with the top picture, but you could use a couple of 45 degree PVC fittings to offset the durso slightly.
Do you mean 45° fittings on the bottom where it comes out of the bulkhead?
 
Yes. You would need to stack two of them which effectively offsets the pipe by an inch or so. If you need a bit more offset, then jut put a short piece of pipe between the two fittings.
 
That one is the mega flo. It is adjustable to control the water level in the corner. To clean just push it down. Then raise it back. I don’t have a filter sponge either
 

TOP 10 Trending Threads

WHAT DO YOU ALWAYS RUN OUT OF AT THE WORST TIME?

  • Salt mix

    Votes: 17 18.9%
  • Fish or coral food

    Votes: 5 5.6%
  • Test kits or reagents

    Votes: 9 10.0%
  • Filter media or replacement fleece

    Votes: 5 5.6%
  • RO/DI filters or supplies

    Votes: 14 15.6%
  • Fragging and repair supplies, like glue or epoxy

    Votes: 10 11.1%
  • I keep a backup of everything

    Votes: 23 25.6%
  • Other (Post in the comments)

    Votes: 7 7.8%
Back
Top
Home
Post thread…
Market
What's new