Plumbing my first tank

markysgirl

Active Member
View Badges
Joined
Sep 14, 2018
Messages
135
Reaction score
130
Location
Fort Worth
What state or country do you live in
Texas
Rating - 0%
0   0   0
I put a 2.5 in piece in between the tee and the Barb but when I dry fit it, I end up with quite a bit more than .5 inches between them. Will it "shrink" once I glue them together permanently? I know the glue lubricates the pieces....
IMG_20191223_161111.jpg
 
I have measured to the stopping point inside the fittings, the 3/4 fittings are 1 inch deep. So when I measure and cut a piece I measure how much I need and then add 2 inches then cut. It seems like I end up with quite a bit over what I needed.
 
Ya. The glue will act as a lube and make it easier to get the piece farther into the joints. When dry fitting you can never get them that far in unless you really work at it. Then its near impossible to get them apart.
When you assemble that section, try to do it outside the tank so you can get more leverage to push it in futher if you are concerned.
 

TOP 10 Trending Threads

WHAT DO YOU ALWAYS RUN OUT OF AT THE WORST TIME?

  • Salt mix

    Votes: 17 18.7%
  • Fish or coral food

    Votes: 5 5.5%
  • Test kits or reagents

    Votes: 9 9.9%
  • Filter media or replacement fleece

    Votes: 5 5.5%
  • RO/DI filters or supplies

    Votes: 14 15.4%
  • Fragging and repair supplies, like glue or epoxy

    Votes: 10 11.0%
  • I keep a backup of everything

    Votes: 24 26.4%
  • Other (Post in the comments)

    Votes: 7 7.7%
Back
Top
Home
Post thread…
Market
What's new