Quick plumbing question

[BAMatter]

Need to reduce from a 1” PVC fitting down to 1/2” barb for vinyl tubing. What would be the best and most direct way? I keep trying to plan it out but come up with several adapters, thinking there has to be an easier way… was thinking about a 1” spigot x 1/2” slip, but can’t figure out the 1/2” slip to barb connection… thanks in advance.

 

[Saltyreef]

You can do it like this...

https://www.pvcfittingsonline.com/1...qMJlU2vpxkD8ypZJasbm6whZZTxHvSFBoCy5UQAvD_BwE
Then this to fit inside the 1/2" slip.

https://www.pvcfittingsonline.com/1...0U86gSh6O6K0j7XtdadbW4oABUIqDWFBoCqsQQAvD_BwE
Should be the right size...you can also try home depot or lowes. Some have stock...

 

[Saltyreef]

Or if you already have the 1" slip coupler just get a reducer bushing to 1/2" slip to keep it low pro....then put the spigot barb in there.

 

[DeniseAndy]

Most hose barb connections will fit in the sch 40 pvc. I have done this many times. If you are glueing (which sounds like you are), you may want to look for a barb that goes from 1" end to 1/2" tubing. I have a few like this on hand so I know they exist. Good luck!

 

[GillMeister]

Get a 1" x 1/2" schedule 40 pvc reducer fitting with the 1/2" end having ftp threads. Also get a nylon 1/2" barbed fitting and screw it into place with ptfe thread tape. The nylon will handle the stress of forcing the tubing on better than pvc.

 

[BAMatter]

Or if you already have the 1" slip coupler just get a reducer bushing to 1/2" slip to keep it low pro....then put the spigot barb in there.

Think I got it. BRS carries the 1” spigot to 1/2” slip, then I can put that 1/2” spigot to barb you linked in that. Thanks

 

[BAMatter]

Most hose barb connections will fit in the sch 40 pvc. I have done this many times. If you are glueing (which sounds like you are), you may want to look for a barb that goes from 1" end to 1/2" tubing. I have a few like this on hand so I know they exist. Good luck!

Can’t find this fitting, I’ve been trying trust me. Need a 1” spigot to 1/2” barb.

 

[DeniseAndy]

Not sure where you are, but try PVCFittings.com, Off hand cannot remember the others.

 

[BAMatter]

Not sure where you are, but try PVCFittings.com, Off hand cannot remember the others.

Think I found it… This should go right into the slip 1” T.

 

[Saltyreef]

Think I found it… This should go right into the slip 1” T.

Nice!

 

[BAMatter]

Thanks everyone… don’t know why it was such a struggle for me to find. Must be losing my mind

 

[BAMatter]

Get a 1" x 1/2" schedule 40 pvc reducer fitting with the 1/2" end having ftp threads. Also get a nylon 1/2" barbed fitting and screw it into place with ptfe thread tape. The nylon will handle the stress of forcing the tubing on better than pvc.

Thanks for your help