Randy's Tank and Learn Thread

Freenow54

5000 Club Member
View Badges
Joined
Mar 5, 2021
Messages
6,576
Reaction score
5,096
Location
Ontario Canada
Rating - 0%
0   0   0
Refugium Lighting

Looks like I need to change my refugium lighting setup. In Brute can #1, the bubbles coming into the can from the water coming down from the display have cause enough salt spray from popping that the led bulb shorted and tripped the gfi.

Another lesson that I already knew but ignored, spread out the plugs in gfi in a way that there’s not important things tripping each other. In this case, the ATO also went out. Rinsing the bulb in tap water and placing it on a dehumidifier to dry seems to have fixed it.

I decided that, at least temporarily, I can put a glass sheet between the bulb and the spray. It would work, but at least in Brute 1 the spray is already visibly getting into the glass (in 30 min).

Long term, at least in Brute 1, I may need floss or something to trap bubbles. I’m open to suggestions of how to stop bubbles. :)




IMG_3075.jpeg
IMG_3074.jpeg
Also as I harped on in other threads And this example is textbook, Ask an Electrician consider ARC Protection on Receptacle or entire breaker
 
OP
OP
Randy Holmes-Farley

Randy Holmes-Farley

Reef Chemist
View Badges
Joined
Sep 5, 2014
Messages
89,262
Reaction score
92,305
Location
Massachusetts, United States
Rating - 0%
0   0   0
Also as I harped on in other threads And this example is textbook, Ask an Electrician consider ARC Protection on Receptacle or entire breaker

The breaker is a gfi, which might be a mistake since it may cause all the gfi outlets (5) on that circuit to shut down from one device issue. :)
 
OP
OP
Randy Holmes-Farley

Randy Holmes-Farley

Reef Chemist
View Badges
Joined
Sep 5, 2014
Messages
89,262
Reaction score
92,305
Location
Massachusetts, United States
Rating - 0%
0   0   0
Pool noodle to the rescue!

Looks like the bubbles were stopped perfectly with a section of an old pool noodle with a couple of zip ties through the center. :)
IMG_3077.jpeg
IMG_3076.jpeg
 
OP
OP
Randy Holmes-Farley

Randy Holmes-Farley

Reef Chemist
View Badges
Joined
Sep 5, 2014
Messages
89,262
Reaction score
92,305
Location
Massachusetts, United States
Rating - 0%
0   0   0
Please research Arc Protection . It can protect against fires in the walls
Yes, I have arc faults in the barn. Caused us to do a bunch of rewiring due to odd wiring where electricity went out one breaker and back another.
 

Miami Reef

Reef Chem Enthusiast
View Badges
Joined
Sep 8, 2017
Messages
17,255
Reaction score
29,618
Location
Miami
Rating - 0%
0   0   0
Pool noodle to the rescue!

Looks like the bubbles were stopped perfectly with a section of an old pool noodle with a couple of zip ties through the center. :)
IMG_3077.jpeg
IMG_3076.jpeg
Your PhD went to good use!
 
OP
OP
Randy Holmes-Farley

Randy Holmes-Farley

Reef Chemist
View Badges
Joined
Sep 5, 2014
Messages
89,262
Reaction score
92,305
Location
Massachusetts, United States
Rating - 0%
0   0   0
Nutrient testing

Got my Hanna HI 774 phosphate ULR from Amazon. Tested tank water twice: 0.16 and 0.17 ppm. Plenty of phosphate without being above my concern trigger of 0.3 ppm. Not sure where it came from. Maybe I overdosed early on, or from rocks (old or new) or maybe dying local macroalgae from the ocean (cannot really tell).

Did some additional testing with my Hanna HI 782 Marine Nitrate HR, and got 0 again. Could mean 0-2 ppm, which seems low to me. I had stopped the ammonia dosing when the first batch of rock came, but time to restart. I think I’ll just add 0.1 ppm per day for a while. I manually added that as ammonium bicarbonate just now while I get auto dosing set up again.

My better BRS 1.1 mL per min doser (unused in box but at least 10 years old) is being used for phyto. Pulling out my two old used ones, one doses 0.89 mL per min (tested over two 20-min periods) and one doses nothing. It’s an easy decision which to use, and using the stock solution I made (4.3 mg/mL) it will take about 21 mL per day for the full system of about 900 L.

Thus, I’ll set this timer for about 24 minutes per day of ammonia dosing. I made it a few weeks ago, but it is in a glass bottle with a screw cap so I expect the concentration is unchanged.
 

Pod_01

Valuable Member
View Badges
Joined
Jan 10, 2022
Messages
1,753
Reaction score
1,552
Location
Waterloo
Rating - 0%
0   0   0
Looks like I need to change my refugium lighting setup. In Brute can #1, the bubbles coming into the can from the water coming down from the display have cause enough salt spray from popping that the led bulb shorted and tripped the gfi.
So I never used refugium, but after few recent discussions I decided to try one, mainly to raise pH at night.
To make long story short I decided on the following light:
1746410630786.jpeg

Not sure if it is good or bad but what I liked about it is that it can be submerged under water.
With all the potentials to spray water in the sump I think it is really neat idea.
I use it submerged and no spray concern…
 

twentyleagues

5000 Club Member
View Badges
Joined
Mar 27, 2023
Messages
6,275
Reaction score
7,181
Location
Flint
Rating - 100%
1   0   0
So I never used refugium, but after few recent discussions I decided to try one, mainly to raise pH at night.
To make long story short I decided on the following light:
1746410630786.jpeg

Not sure if it is good or bad but what I liked about it is that it can be submerged under water.
With all the potentials to spray water in the sump I think it is really neat idea.
I use it submerged and no spray concern…
I like the idea but I do have concerns that the lens will grow algae. Any issues with this? I also dont like pink fuge lights I like natural 6500-8000k lighting for my macros. I do understand that the pink color will grow macros and it does it pretty well most green ones anyway reds seem to like more white light.
 

Miami Reef

Reef Chem Enthusiast
View Badges
Joined
Sep 8, 2017
Messages
17,255
Reaction score
29,618
Location
Miami
Rating - 0%
0   0   0
You’re doing a great job with the nutrients, Randy.

0.17ppm is actually great. Nothing will be PO4 limited. The corals will be nice and fluffy.

I agree that adding ammonium bicarbonate is the optimal next step for nitrate.

So far so good!
 

rishma

2500 Club Member
View Badges
Joined
Nov 15, 2009
Messages
2,757
Reaction score
2,500
Rating - 0%
0   0   0
So I never used refugium, but after few recent discussions I decided to try one, mainly to raise pH at night.
To make long story short I decided on the following light:
1746410630786.jpeg

Not sure if it is good or bad but what I liked about it is that it can be submerged under water.
With all the potentials to spray water in the sump I think it is really neat idea.
I use it submerged and no spray concern…
I was going to recommend the same lights.
 

rishma

2500 Club Member
View Badges
Joined
Nov 15, 2009
Messages
2,757
Reaction score
2,500
Rating - 0%
0   0   0
Nutrient testing

Got my Hanna HI 774 phosphate ULR from Amazon. Tested tank water twice: 0.16 and 0.17 ppm. Plenty of phosphate without being above my concern trigger of 0.3 ppm. Not sure where it came from. Maybe I overdosed early on, or from rocks (old or new) or maybe dying local macroalgae from the ocean (cannot really tell).



Did some additional testing with my Hanna HI 782 Marine Nitrate HR, and got 0 again. Could mean 0-2 ppm, which seems low to me. I had stopped the ammonia dosing when the first batch of rock came, but time to restart. I think I’ll just add 0.1 ppm per day for a while. I manually added that as ammonium bicarbonate just now while I get auto dosing set up again.

My better BRS 1.1 mL per min doser (unused in box but at least 10 years old) is being used for phyto. Pulling out my two old used ones, one doses 0.89 mL per min (tested over two 20-min periods) and one doses nothing. It’s an easy decision which to use, and using the stock solution I made (4.3 mg/mL) it will take about 21 mL per day for the full system of about 900 L.

Thus, I’ll set this timer for about 24 minutes per day of ammonia dosing. I made it a few weeks ago, but it is in a glass bottle with a screw cap so I expect the concentration is unchanged.

I have seen reports that phytoplankton dosing can cause nutrients to go down. I have never done it consistently enough to comment. I suppose zero nitrate isn’t a big surprise especially if you are not feeding fish.

When is the yellow tang coming?
 
OP
OP
Randy Holmes-Farley

Randy Holmes-Farley

Reef Chemist
View Badges
Joined
Sep 5, 2014
Messages
89,262
Reaction score
92,305
Location
Massachusetts, United States
Rating - 0%
0   0   0
So I never used refugium, but after few recent discussions I decided to try one, mainly to raise pH at night.
To make long story short I decided on the following light:
1746410630786.jpeg

Not sure if it is good or bad but what I liked about it is that it can be submerged under water.
With all the potentials to spray water in the sump I think it is really neat idea.
I use it submerged and no spray concern…
Thanks. I’ve seen those. I’ll keep them in mind.

If one goes by watts only, I’d need 14 of them to match the intensity I have now.
 
OP
OP
Randy Holmes-Farley

Randy Holmes-Farley

Reef Chemist
View Badges
Joined
Sep 5, 2014
Messages
89,262
Reaction score
92,305
Location
Massachusetts, United States
Rating - 0%
0   0   0
I have seen reports that phytoplankton dosing can cause nutrients to go down. I have never done it consistently enough to comment. I suppose zero nitrate isn’t a big surprise especially if you are not feeding fish.

When is the yellow tang coming?
I’ve heard that too. Not sure I am 100% convinced, but that may be contributing.

There’s no hard date on the fish, but I expect to arrange them with Dr Reef for very soon after the second rock arrives, which is presently scheduled for May 15. Along with the yellow tang will be a pair of mandarins and some green chromis.
 
OP
OP
Randy Holmes-Farley

Randy Holmes-Farley

Reef Chemist
View Badges
Joined
Sep 5, 2014
Messages
89,262
Reaction score
92,305
Location
Massachusetts, United States
Rating - 0%
0   0   0
0.17ppm is actually great. Nothing will be PO4 limited. The corals will be nice and fluffy.

I agree that adding ammonium bicarbonate is the optimal next step for nitrate.

So far so good!

Now that you mention it, corals are coming fast. Dwest has very kindly offered to send me some corals from his long standing tank. They are planned for about 5 days after the final rock arrives.

Chief among these is a baby elegance (the little guy in the front bottom) from an elegance that he has had for 30 years.

1746444657240.jpeg

1746444800840.jpeg
 
OP
OP
Randy Holmes-Farley

Randy Holmes-Farley

Reef Chemist
View Badges
Joined
Sep 5, 2014
Messages
89,262
Reaction score
92,305
Location
Massachusetts, United States
Rating - 0%
0   0   0
Two other corals that are coming from Dwest are a cali tort and a green leather. He is moving his home and tank so there is a window of opportunity to get them, but one implication is that both will be unmounted. I’ve never mounted a hard coral in my life. He gave me some good advice on how to do it, but I’ll take and tips and suggestions so I don’t screw it up. lol
 
OP
OP
Randy Holmes-Farley

Randy Holmes-Farley

Reef Chemist
View Badges
Joined
Sep 5, 2014
Messages
89,262
Reaction score
92,305
Location
Massachusetts, United States
Rating - 0%
0   0   0
Finally, DIY reefer has very kindly offered me a frag of a yellow Fiji leather. I had one years ago and loved it. It should look good in my lighting. No exact shipping date sent, but it will be soon too. This is his mother colony:


1746445447403.jpeg
 

TOP 10 Trending Threads

WHAT AMOUNT OF LIVE ROCK AND SAND SHOULD BE PRIORITIZED FOR OPTIMAL BIODIVERSITY/FILTRATION?

  • 100% live rock + bagged sand

    Votes: 37 27.2%
  • 100% dry rock + 100% live sand

    Votes: 46 33.8%
  • 50/50 live/dry rock, 50/50 live/bagged sand

    Votes: 30 22.1%
  • 75% live rock, 25% live sand

    Votes: 13 9.6%
  • 25% live rock, 75% live sand

    Votes: 10 7.4%
Back
Top