I did some changes / corrections to my sump.
Finally I turned on the second return pump that was stopped.
Now I have a Water Blaster 7000 sending water to the display / frag tank/ chiller / reactors, connected to the nobreak and a Water Blaster 5000, sending water to the display. This is connected to the Apex.
Thus the turn over more than doubled.
I also made some corrections to the plumbing.
I took the whole siporax to wash and I don't know if I will return it to the tank.
I removed the rocks that were in a compartment under the skimmer and brought to the sump where the return pump is, but these rocks must also come out.
I siphoned the bottom of the sump and removed a lot of "dust".
I took the zeolites out of the phosban reactors and put active carbon in one.
I must go back to using biopellets in one and GFO in the other to reduce my Nitrate / Phosphate ....
Tomorrow I'll fix some more things and when it's all right I'll take some updated photos of the fish room.
Finally I turned on the second return pump that was stopped.
Now I have a Water Blaster 7000 sending water to the display / frag tank/ chiller / reactors, connected to the nobreak and a Water Blaster 5000, sending water to the display. This is connected to the Apex.
Thus the turn over more than doubled.
I also made some corrections to the plumbing.
I took the whole siporax to wash and I don't know if I will return it to the tank.
I removed the rocks that were in a compartment under the skimmer and brought to the sump where the return pump is, but these rocks must also come out.
I siphoned the bottom of the sump and removed a lot of "dust".
I took the zeolites out of the phosban reactors and put active carbon in one.
I must go back to using biopellets in one and GFO in the other to reduce my Nitrate / Phosphate ....
Tomorrow I'll fix some more things and when it's all right I'll take some updated photos of the fish room.