Redundant Heating

  • Thread starter Thread starter dbroncos
  • Start date Start date
  • Tagged users Tagged users None

dbroncos

Active Member
View Badges
Joined
Jan 19, 2011
Messages
356
Reaction score
102
Location
Philadelphia
Rating - 100%
1   0   0
Hello everyone. Have a 53 gallon aquarium (42 gallons in the display tank + 11 gallons in the sump). If I wanted to have two heaters for redundancy what wattage should I get for both?
 
Hello everyone. Have a 53 gallon aquarium (42 gallons in the display tank + 11 gallons in the sump). If I wanted to have two heaters for redundancy what wattage should I get for both?
I have a 40 breeder with a 20 gallon sump. I run with two 150 watt Eheim Jager heaters both on their own Inkbird controllers. Strongly recommend the controllers because your most common point of failure is a heater.
 
I did 2 heaters capable of heating the entire tank solo.

Sizing online should be easy.
 
I have a 40 breeder with a 20 gallon sump. I run with two 150 watt Eheim Jager heaters both on their own Inkbird controllers. Strongly recommend the controllers because your most common point of failure is a heater.
Thanks yes I have an Apex
 
If you keep your home at least mid 60’s F and you have typical evaporation of 1% ish per day, I would try one 100 watt heater. Then adjust your redundant heater sizing based on the performance of the first.

I always use as low wattage as possible to slow any potential over heating issues. I also came full circle back to eheim jagers. But they are longer than others so make sure it fits.
 
The common wisdom is to under power each heater if using two, so if you need 200 watts, two 150 watt heaters. The logic being that you cook your tank less quickly if one sticks on. However, those pointing out using two heaters that each are able to heat the tank alone, also has some logic - since one heater failing off will create the same danger in the opposite direction - if you only then have one underpowered heater, the tank will cool off. Not sure which is better - might have to do with what is the more common failure - a heater that sticks on, or one that shuts off.
 
I have the same tank. I live in North Dakota where there's snow at least 6 months out of the year, So it's cold here. I am using the IM Helio PTC heater system. I have two 100 watt heaters. My temp is set to 76.5 F. Apex turns off the heater if it ever reaches 79, but the Helio keeps it steady

1684114519328.png
 
Last edited:

TOP 10 Trending Threads

WHAT DO YOU ALWAYS RUN OUT OF AT THE WORST TIME?

  • Salt mix

    Votes: 17 18.7%
  • Fish or coral food

    Votes: 5 5.5%
  • Test kits or reagents

    Votes: 9 9.9%
  • Filter media or replacement fleece

    Votes: 5 5.5%
  • RO/DI filters or supplies

    Votes: 14 15.4%
  • Fragging and repair supplies, like glue or epoxy

    Votes: 10 11.0%
  • I keep a backup of everything

    Votes: 24 26.4%
  • Other (Post in the comments)

    Votes: 7 7.7%
Back
Top
Home
Post thread…
Market
What's new