REEF PI HELP!

[James M]

Welcome to reef2reef !!!

 

[Richard Ivory]

 

[KJ]

Welcome to R2R!!!

 

[Emarley]

Welcome to R2R!!!

 

[That Crusso Kid]

Welcome to R2R!

 

[BADHABITS123]

thanks everyone for being so welcoming!

 

[BADHABITS123]

@Ranjib please let me know when you might be available. ive taken the day off work to try and figure out where i have gone wrong. yes this is one of my bad habits lol.

 

[Ranjib]

@Ranjib please let me know when you might be available. ive taken the day off work to try and figure out where i have gone wrong. yes this is one of my bad habits lol.

Can you enable the equipment capability (under configuration-> settings ) and reload reef-pi

 

[BADHABITS123]

Can you enable the equipment capability (under configuration-> settings ) and reload reef-pi

yes sir done

 

[BeejReef]

No sound technical advise here.. Just silly memes and a hearty welcome!

 

[BADHABITS123]

No sound technical advise here.. Just silly memes and a hearty welcome!

lol thanks william

 

[BADHABITS123]

that got my temp working. thanks @Ranjib

 

[Ranjib]

that got my temp working. thanks @Ranjib

Ok. So what next, whats not working? The lights? If so , share details of the failures/errors you are experiencing

 

[BADHABITS123]

thats what im concerned with @Ranjib i see no errors now it was just a 404 not seeing temp sensor. i plug in the kessil and its bright white no control.

 

[BADHABITS123]

thats what im concerned with @Ranjib i see no errors now it was just a 404 not seeing temp sensor. i plug in the kessil and its bright white no control.

i moved the pi and lighting over to my reef tank. i have been using it on my 50 gallon that was finishing cycling for the last few months. nothing but a clean up crue. so i wasn't concerned with the lighting as much as i am now! i dont wanna kill my corals. lol so i started to see progress and i knew you were on board with me to find my problem. thanks again man!

 

[BADHABITS123]

this is on that tank!

 

[Ranjib]

this is on that tank!

Can you share the details about how this light is setup, the screenshot of your connectors page. and which jack is associated with which light. Once we have that, then lets check if we are getting the right voltage..

 

[BADHABITS123]

i did break off the ground pin to the to the kessil plug on my housing and had to re solder but when i grounded it with my fingers it did change im not sure if that tells you anything or not

 

[BADHABITS123]

Can you share the details about how this light is setup, the screenshot of your connectors page. and which jack is associated with which light. Once we have that, then lets check if we are getting the right voltage..

sure

 

[BADHABITS123]

i think this is how ive seen it