Return pump size: based on drain only?

SteveG_inDC

Active Member
View Badges
Joined
Feb 17, 2020
Messages
383
Reaction score
517
Location
Washington, DC
What state or country do you live in
Maryland
Rating - 0%
0   0   0
Should the size of the return pump be based on the capacity of the overflow drain capacity?

That's what I always assumed but there are a lot of old threads on forums saying to push high volume through the sump for efficiency (like 10X water volume). I don't see how you can even do that if the drains can't handle it.

I am planning a 240 display with 100 gallon sump, have a chance to buy a used mag drive. the guy has a mag 12 and a mag 18 and I have a mag 7 and 9 lying around. So many choices.

I have not actually bought the tank yet or specified the size of the holes for the drain plumbing.
 
I have (2) Glass Holes overflow plumbed with 1.5 inch PVC pipes (plumbed Herbie style, 1 full siphon with a gate and 1 emergency/overflow). I had a Fluval Sp4 on the return pushing 1000+ GPH and it was zero problems.

The issue I ran into though was pushing that much water still caused quite a bit of noise through the pipes. I think the issue is my Glass Hole overflow boxes.
 
To make an over flow quiet you usually want 2 things. First a full bean. Second you need to fine tune it just 10 percent more or less water going through the non full syphon can make a world of difference
 
To make an over flow quiet you usually want 2 things. First a full bean. Second you need to fine tune it just 10 percent more or less water going through the non full syphon can make a world of difference

Unfortunately, full bean isn't an option for the way my tank is plumbed right now (double unfortunate because my sump is pre plumbed for 3 drains too). I tried adjusting with a gate valve, but when I couldn't fine tune it to where it was a slight trickle into the overflow/emergency drain. The full siphon would pull too much water and the other drain wouldn't be utilized, or the overflow drain would make noise. I am using a gate valve (instead of a ball valve) too! I ended up switching to a DC return pump and was able to adjust the amount of flow.
 
You should do a Bean style overflow using 3 holes, it's the safest one out there.
I run a Herbie on a 250 with 1" piping but not too much flow. I could go higher with a different pump.
If you want a high flow pump I would do 1.5" piping.
 
Remember - with mag pumps to achieve the rated flow you will need large piping on the return.
Varios pumps are good DC pumps & might suit you better. They run quiet, are adjustable & do not run hot.
 
I'm a big advocate of high turnover. I have a 300 display and I push about 50gpm through it on a 1.5" bean setup. It's all preferance really, but just make sure your drains DO handle whatever your pump can throw at them.
 

TOP 10 Trending Threads

HOW WOULD YOU FEEL ABOUT RECEIVING A FISH OR CORAL AS A HOLIDAY GIFT?

  • I’d love one, as long as it’s a species I chose

    Votes: 19 28.8%
  • I’d trust someone who knows my tank to choose

    Votes: 2 3.0%
  • I’d rather get a gift card and pick it myself

    Votes: 24 36.4%
  • I’d prefer gear or supplies instead

    Votes: 2 3.0%
  • Please don’t surprise me with livestock

    Votes: 19 28.8%
  • Other (Post in the comments)

    Votes: 0 0.0%
Back
Top
Home
Post thread…
Market
What's new