Yesterday I installed a 6 stage RO/DI 75 GPD system with an auto flush, tank float, and booster pump that feeds a 500 gallon storage tank. After 24 hours I have a bit over 100 gallons according to the marks on the tank. The TDS meter has been crazy, but just found that they were installed in the wrong direction and started reading 1 TDS after running for 5 minutes.
My source is well water and has 130 to 190 TDS depending on the time of year the lab test the water.
I will be using around 50 gallons of water 4 to 6 times a week. I was planning on cutting off the unit around half a tank before turning it back on. Is it worth doing this and if so what's the best way to shut if down?
I feel that I have done a good amount of reading on RO/DI, but I'm sure there's more to read. Any suggestions?
Thanks, Thumped
My source is well water and has 130 to 190 TDS depending on the time of year the lab test the water.
I will be using around 50 gallons of water 4 to 6 times a week. I was planning on cutting off the unit around half a tank before turning it back on. Is it worth doing this and if so what's the best way to shut if down?
I feel that I have done a good amount of reading on RO/DI, but I'm sure there's more to read. Any suggestions?
Thanks, Thumped