Rodi connection help

  • Thread starter Thread starter Steve2
  • Start date Start date
  • Tagged users Tagged users None

Steve2

Community Member
View Badges
Joined
Feb 25, 2018
Messages
29
Reaction score
30
What state or country do you live in
Idaho
Rating - 0%
0   0   0
I purchased in RODI unit 2nd hand replace the filters and the Di media. But I was hoping that 1 of you could help with troubleshooting which line goes to what I will attach pictures thank you very much in advance.
20190810_231041.jpg
 
20190810_231026.jpg
 
The initial input is the sediment filter. So you go sediment filter to carbon filter to ro membrane to di filter. The yellow line is the "good" water from the ro membrane and is correctly going to the di filter. The other line from the ro membrane is the "waste" water. Unless you are going to hook the ro unit up to some type of auto shutoff you don't need the white "block" with the orange tubing. That is a solenoid and is used to protect the ro membrane from back pressure when hooked up to a auto shutoff situation such as a drinking water tank or water reservoir with a float valve. You can remove it if not needed and install a push connect for the tubing.
 
You are awwsome bro! Thank you so much!
 

TOP 10 Trending Threads

WHAT DO YOU ALWAYS RUN OUT OF AT THE WORST TIME?

  • Salt mix

    Votes: 17 18.9%
  • Fish or coral food

    Votes: 5 5.6%
  • Test kits or reagents

    Votes: 9 10.0%
  • Filter media or replacement fleece

    Votes: 5 5.6%
  • RO/DI filters or supplies

    Votes: 14 15.6%
  • Fragging and repair supplies, like glue or epoxy

    Votes: 10 11.1%
  • I keep a backup of everything

    Votes: 23 25.6%
  • Other (Post in the comments)

    Votes: 7 7.8%
Back
Top
Home
Post thread…
Market
What's new