- Joined
- Aug 14, 2015
- Messages
- 407
- Reaction score
- 618
Normally the boards will have 2 pairs of wires, one at each end. A black and a red on each side, that is it. If you have 3 sets of wires it may be a 3 channel board with moonlight. Which model Galaxy hydro do you have? Or better yet post up or send me a picture of your board with the wires before you order. I want to make sure it will work for you. The only lights we have found that they will not work with are 3-channel boards since you obviously would lose the moonlight channel, though the boards would still work. The diodes that would normally be in your third channel would instead be part of the blue Channel.Probably going to be placing my order today or this weekend for an upgrade board, good to know I can get this spread on my 16"! Will most likely upgrade later but this is plenty for now! I have the Galaxy Hydro unit though and wasn't sure if I needed to swap any wire clips or not? I have 3 wires connected to my current LED board.
Thanks!
Salt
The only other light the board has not worked with are the Evergrow and Galaxy hydro Wi-Fi lights. For some reason that manufacturer decided to put the Wi-Fi chips directly onto the board rather than as a separate unit. So if your Wi-Fi goes out you have to replace the entire unit, and if you're board goes out you have to replace the entire unit. Since our PCB board would not include the Wi-Fi chips, it would not work for those units.
Long story short, contact me before you order and let's make sure it's going to work for you.