Suggestions on cooling system for nano

[GothFishKeeper]

I have a Fluval Evo 13.5g and the eshopps nano skimmer pump is producing too much heat for a stable temp even when my heater is turned off. I need suggestions for a cooling fan or system, ideally that would fit in the empty chamber of my filtration compartment on the side
(9cm x 7cm x 1ft).

 

[C_AWOL]

A simple fan blowing over the surface might work reasonably at dropping the temp by 1-2 degrees F depending on ambient humidity.

 

[GothFishKeeper]

I thought about that but I need the lid on my tank because of cats. That’s why I’d prefer to have it in the filter chamber. If I have to get a mesh lid for it I can but then there’s the issue of the 3.5" x 3.5" hole in the corner for my skimmer. I modified the stock lid for that purpose (as seen in picture) but I don’t know how I would do that for a mesh lid

 

[RaymondL]

I thought about that but I need the lid on my tank because of cats. That’s why I’d prefer to have it in the filter chamber. If I have to get a mesh lid for it I can but then there’s the issue of the 3.5" x 3.5" hole in the corner for my skimmer. I modified the stock lid for that purpose (as seen in picture) but I don’t know how I would do that for a mesh lid

You might need one of these?

https://www.etsy.com/ca/listing/127...how_sold_out_detail=1&ref=nla_listing_details

 

[echo11011]

I have a Fluval Evo 13.5g and the eshopps nano skimmer pump is producing too much heat for a stable temp even when my heater is turned off. I need suggestions for a cooling fan or system, ideally that would fit in the empty chamber of my filtration compartment on the side
(9cm x 7cm x 1ft).

This is what i did to mine: Thread 'Fluval evo 13.5 overheating solution' https://www.reef2reef.com/threads/fluval-evo-13-5-overheating-solution.1069115/