Phil Adams
New Member
Hi folks I have an odd doser problem which I can’t find an answer for online wondering if anyone can shed some light please.
I have three of these dosers, separate power supplies, all connected to my not too old iPad via BLUETOOTH. The oldest I’ve had a bit over a year, the other two obviously less.
So I’ve decided to change dosing from alk and calc onto All For Reef and the doser that freed up I was going to start with a low dose of Kalk.
Cut a long story a bit shorter, renaming the dosers and updating the intended doses, I’m not convinced the dosers have updated, the LEDs on all three are flashing bright bright, and once connected, if I close the app and try to reconnect the tablet says it’s unable to connect, same in each case. This is the same whether I’m next to them or in the next room. The only way I can get them to connect it to switch each doser off and back on again, but once you’ve closed one doser on the app and gone to the next one, the first one will be disconnected and unable to connect when you go back to it.
And yes, I’ve restarted the iPad. The only things I haven’t tried are leaving the dosers off for a while to completely power down, and deleting them from the app and starting again. I was hoping to save the dosing information I had set up ideally. They worked just fine before. All three of them won’t have broken at the same time, there must be a solution.
Any ideas?
Thanks, Phil
I have three of these dosers, separate power supplies, all connected to my not too old iPad via BLUETOOTH. The oldest I’ve had a bit over a year, the other two obviously less.
So I’ve decided to change dosing from alk and calc onto All For Reef and the doser that freed up I was going to start with a low dose of Kalk.
Cut a long story a bit shorter, renaming the dosers and updating the intended doses, I’m not convinced the dosers have updated, the LEDs on all three are flashing bright bright, and once connected, if I close the app and try to reconnect the tablet says it’s unable to connect, same in each case. This is the same whether I’m next to them or in the next room. The only way I can get them to connect it to switch each doser off and back on again, but once you’ve closed one doser on the app and gone to the next one, the first one will be disconnected and unable to connect when you go back to it.
And yes, I’ve restarted the iPad. The only things I haven’t tried are leaving the dosers off for a while to completely power down, and deleting them from the app and starting again. I was hoping to save the dosing information I had set up ideally. They worked just fine before. All three of them won’t have broken at the same time, there must be a solution.
Any ideas?
Thanks, Phil
