Torch not doing well

Aquacrazed

Active Member
View Badges
Joined
Nov 14, 2021
Messages
134
Reaction score
58
Location
Vancouver, BC
Rating - 0%
0   0   0
Sorry I'm not able to get a clear shot of this but my 24k torch is not opening up and there is a little bit of rotting in the circled area. Any advice on what I should do? I have been battling dinos the last month and have been soding silicates daily, no water changes and my tank looks ugly right now.

Calcium: 530
Alk: 8.5
Magnesium: 1450
Nitrates: 10
Phosphates: .2

24k.png
 

bluemon

Lazy DIY Reefer
View Badges
Joined
Jun 20, 2017
Messages
2,620
Reaction score
2,507
Location
California
Rating - 0%
0   0   0
Research brown jelly disease, it might be a good starting point.
 

VintageReefer

10K Club member
View Badges
Joined
Nov 16, 2023
Messages
19,172
Reaction score
34,122
Location
USA
Rating - 100%
3   0   0
It appears the flesh band is eroding on the lower half, number of possible causes but primary ones are too much linear flow and / or water quality

I would put it in a hydrogen peroxide and sw dip, blast off the decay, and allow the dip to sterilize the coral for a few min

Then place in good lighting and lower flow for healing. A dip product like Coral Infection Elimination is great for situations like this, to prevent / fight off early stages of infection. That torch is able to be saved if you have the right stuff on hand.
 

VintageReefer

10K Club member
View Badges
Joined
Nov 16, 2023
Messages
19,172
Reaction score
34,122
Location
USA
Rating - 100%
3   0   0
What will happen next is the flesh band will continue to erode, thus making an opening between the water and the innards of the coral itself. That is a doorway for everyday bacteria to get inside, and that is how infection begins, and becomes bjd quickly.

Keeping that area clean, and giving good conditions to heal, are the needed steps at this point
 
OP
OP
Aquacrazed

Aquacrazed

Active Member
View Badges
Joined
Nov 14, 2021
Messages
134
Reaction score
58
Location
Vancouver, BC
Rating - 0%
0   0   0
It appears the flesh band is eroding on the lower half, number of possible causes but primary ones are too much linear flow and / or water quality

I would put it in a hydrogen peroxide and sw dip, blast off the decay, and allow the dip to sterilize the coral for a few min

Then place in good lighting and lower flow for healing. A dip product like Coral Infection Elimination is great for situations like this, to prevent / fight off early stages of infection. That torch is able to be saved if you have the right stuff on hand.
Thanks, what concentration of hydrogen peroxide should I use? 1:1 with saltwater?
 

VintageReefer

10K Club member
View Badges
Joined
Nov 16, 2023
Messages
19,172
Reaction score
34,122
Location
USA
Rating - 100%
3   0   0
Thanks, what concentration of hydrogen peroxide should I use? 1:1 with saltwater?
Follow this guide for all coral types

The amount in ml is a range, I always go for the high end of the range. This is the amount of 3% hydrogen peroxide to add to 1 liter of saltwater. The duration is 5 min then you simple baste off any slime or loose stuff and return the coral to the display

 
OP
OP
Aquacrazed

Aquacrazed

Active Member
View Badges
Joined
Nov 14, 2021
Messages
134
Reaction score
58
Location
Vancouver, BC
Rating - 0%
0   0   0
Follow this guide for all coral types

The amount in ml is a range, I always go for the high end of the range. This is the amount of 3% hydrogen peroxide to add to 1 liter of saltwater. The duration is 5 min then you simple baste off any slime or loose stuff and return the coral to the display

I've also heard about iodine dips. I do have some at home (10% solution). Any thoughts on this?
 

VintageReefer

10K Club member
View Badges
Joined
Nov 16, 2023
Messages
19,172
Reaction score
34,122
Location
USA
Rating - 100%
3   0   0
I've also heard about iodine dips. I do have some at home (10% solution). Any thoughts on this?
Also effective for bacterial issues but will not affect algae or algae films
 

TOP 10 Trending Threads

WHAT AMOUNT OF LIVE ROCK AND SAND SHOULD BE PRIORITIZED FOR OPTIMAL BIODIVERSITY/FILTRATION?

  • 100% live rock + bagged sand

    Votes: 34 27.0%
  • 100% dry rock + 100% live sand

    Votes: 45 35.7%
  • 50/50 live/dry rock, 50/50 live/bagged sand

    Votes: 27 21.4%
  • 75% live rock, 25% live sand

    Votes: 11 8.7%
  • 25% live rock, 75% live sand

    Votes: 9 7.1%
Back
Top