- Joined
- Jun 16, 2019
- Messages
- 272
- Reaction score
- 117
Hi there,
I just set up a new tunze 3155 and I’m hoping someone can help me troubleshoot what is going wrong.
every time I plug in the unit the water starts to pump for a few seconds, so I know the pump is working.
The problem is that whenever I move the sensors around to test whether it is sensing water level changes, nothing happens. I move the sensor from almost fully underwater to completely above water, and the pump does not kick on?
I have tested where I unplug the unit, and then move the sensor so it is partially submerged and then plug the unit in. After the initial fill I can’t get it to react to any changes I make.
the high level float switch works as the alarm goes off when I move it manually, but I can’t get the optical sensor to start filling the tank no matter how I move or orient it.
Anyone have any suggestions? Hoping I don’t have a bad sensor :/
I just set up a new tunze 3155 and I’m hoping someone can help me troubleshoot what is going wrong.
every time I plug in the unit the water starts to pump for a few seconds, so I know the pump is working.
The problem is that whenever I move the sensors around to test whether it is sensing water level changes, nothing happens. I move the sensor from almost fully underwater to completely above water, and the pump does not kick on?
I have tested where I unplug the unit, and then move the sensor so it is partially submerged and then plug the unit in. After the initial fill I can’t get it to react to any changes I make.
the high level float switch works as the alarm goes off when I move it manually, but I can’t get the optical sensor to start filling the tank no matter how I move or orient it.
Anyone have any suggestions? Hoping I don’t have a bad sensor :/