UV plumbing question

[wesman42]

I am going to be installing a 55W UV in my system in a few days. I'll be using 3/4" hose. I have a simple question about using Barb fittings.

Do I just use zip ties to hold the hose onto each end + pump? I'm worried about leaks.

 

[JoshH]

These are the best clips to use for vinyl/soft tubing to barb fittings :) Be sure to place them between the ribs of the barbed fittings before you snug them up. This will ensure the compression holds the tubing snuggly on the barbs.

https://www.bulkreefsupply.com/ratchet-clamp-for-tubing-1-6684828461f4e5bda1e2a33b5e0db6d3.html

 

[theMeat]

If hose is tightly pushed on it won’t leak

 

[JoshH]

If hose is tightly pushed on it won’t leak

That too lol I ran my Manifold with no ties of any kind on the barbed fittings with zero leaks. But doesn't hurt to have a little extra security:)

 

[wesman42]

That too lol I ran my Manifold with no ties of any kind on the barbed fittings with zero leaks. But doesn't hurt to have a little extra security:)

Ah, yes I wanted to avoid yet ANOTHER brs order (and the associated waiting time)...so I guess I'll use zip ties for now, then order them in the future when I refresh other things like my group/carbon.


Thanks for the help!!

 

[pecan2phat]

Depends if the hose is soft enough to conform for a tight fit, some of the heavy duty vinyl hoses are too hard to close all the gaps around a barbed fitting.
The ratchet clamps are a good peace of mind.

 

[JoshH]

Ah, yes I wanted to avoid yet ANOTHER brs order (and the associated waiting time)...so I guess I'll use zip ties for now, then order them in the future when I refresh other things like my group/carbon.


Thanks for the help!!

I think Marine Depot carries them as well;):p but as @theMeat says above as long as they are snug you should be good.